True$/$False $-$ Indicate whether the statement made is true or false by writing $T$ or $F$ to

the left of the sentence.

A set of construction prints usually includes a door schedule & a window schedule.

Trades workers who specialize in finishing gypsum board work are called Tapers.

Commercial stair treads must be at least $11"$ wide measured from riser to riser.

The actual size of a nominal $26$ board is $2xx6".$

Risers for exterior stairs should be $7"$ to $8"$ high.

Trim refers to molding installed around window and door openings.

Exact tread and riser sizes are based on the total rise and total run of a stairway.

The double$-$ply system of wallboard offers lower sound transmission than the single$-$ply

system.

Preferred angles for stairs' stringers inclination should fall between $30$ and $35$ degrees.

The locations of all door and window openings are shown on the foundation plan.

Handrails for residential construction should not be between $34$inches and $38$inches.

Joints in drywall installation should be staggered when possible.

The blade of a framing square is $3"$ wide and $24$ long.

$4\frac{\frac{1}{2}}{?}$ clearance is allowed at the sides and top of the doorjamb.

Jafety is not a major concern in stairway design.

When installing drywall, a typical fastening spacing for screws is $7"$ apart.

The term level refers to the vertical position of an object in reference to the ground.

Respiratory protection is required when workers are exposed to airborne hazards.