Question: Two solid cylindrical rods are joined at B and loaded as shown. Rod AB is made of steel (E=200 GPa), and rod BC of

Two solid cylindrical rods are joined at B and loaded as shown.

Two solid cylindrical rods are joined at B and loaded as shown. Rod AB is made of steel (E=200 GPa), and rod BC of brass (E=100 GPa). Determine (a) the total deformation of the composite rod ABC, (b) the deflection of point B. 760 mm -75 mm B 130 kN 130 kN 1000 mm 50 mm P-180 kN

Step by Step Solution

★★★★★

3.42 Rating (165 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

Answer Length of ... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Accounting Questions!

Two steel tubes are joined at B by four pins (dp = 11 mm), as shown in the cross section a-a in the figure. The outer diameters of the tubes are dAB = 40 mm and dBC = 28 mm. The wall thicknesses are...

The composite beam is made of steel (A) bonded to brass (B) and has the cross section shown. If it is subjected to a moment of M = 6.5 kN m, determine the maximum bending stress in the brass and...

The composite beam is made of steel (A) bonded to brass (B) and has the cross section shown. If the allowable bending stress for the steel is (Ï allow ) st = 180 MPa, and for the brass (Ï...

A reinforced concrete beam of length 5 meters is subjected to a uniformly distributed load of 6 kN/m along its entire length. The cross-sectional dimensions of the beam are 300 mm x 500 mm (width x...

A copper rod and an aluminum rod of the same length and cross-sectional area are attached end to end (Fig. 14-18). The copper end is placed in a furnace maintained at a constant temperature of 250oC....

A torque-to-yield bolt connects two solid cylindrical shafts, Shaft A and Shaft B, in a mechanical system. The bolt has a diameter of 10 mm and is tightened using a torque wrench. The yield strength...

Two identical thin rods, each with mass m and length L, are joined at right angles to form an L-shaped object. This object is balanced on top of a shath edge (Fig. 13.41). If the L-shaped object is...

(a) A yo-yo is made of two solid cylindrical disks, each of mass 0.050 kg and diameter 0.075m, joined by a (concentric) thin solid cylindrical hub of mass 0.0050 kg and diameter 0.010m. Use...

Two rods are connected by a slider block as shown. Neglecting the effect of friction, determine the couple MA required to hold the system in equilibrium. 200 D. 200 mm 15 N-m

Two rods are connected by a slider block as shown. Neglecting the effect of friction, determine the couple e MA required to hold the system in equilibrium. D. 200 mm 25 200 mm B15 N.m

The average annual price of single-family homes in a county between 2007 and 2017 is approximated by the function P(t) = -0.31713+ 6.66717 - 28.4041 + 260 (0 s t s 10) where Pit) is measured in...

In a local boutique, you intend to buy a handbag with an original price of $38, a jacket with an original price of $189, and a scarf with an original price of $23. Currently, the store is running a...

Please use the following information to answer the next question: A US firm's Accounts Payables (in UK) due in 1 year GBP 5,000,000 Current Spot rate for GBP is $2.00 Annual interest rate in US is 5%...

Epsilon inc. has just paid a dividend of $3 per share, and it is expected to pay a dividend of $3.15 per share in one year's time. Assuming that required return is 13% and the dividend growth will...

FAR 9.104-5 certification regarding responsibility matters is a DOD federal Acquisition Regulation that addresses the purchasing and disposition of items that are nonconforming. Explain.

Bob Martino has a checking account with a local bank. Under SEC independence rules, which condition would allow him to work on the firm's audit of the bank? The amount of money in his account is not...

Analyze the following problem: ( Retrieve of Gaddis, T . , 2 0 1 8 , p . 2 2 5 ) Programming Challenges, 1 7 . Personal Best, Chapter 4 . Personal Best Write a program that asks for the name of a...

Linda Lopez opened a beauty studio, Lindas Salon, on January 2, 2011. The salon also sells beauty supplies. In January 2012, Lopez realized she had never filed any tax reports for her business and...

An air-filled rubber ball has a diameter of 6 in. If the air pressure within the ball is increased until the diameter becomes 7 in., determine the average normal strain in the rubber.

The lap joint is connected together using a 1.25 in. diameter bolt. If the bolt is made from a material having a shear stressstrain diagram that is approximated as shown, determine the permanent...

The linkage is made of three pin-connected A992 steel members, each having a diameter of 1¼ in. If a horizontal force of P = 60 kip is applied to the end B of member AB, determine the...

Compute a simple price index for each of the three items. Use 2000 as the baseperiod.

Compute Paasches index for 2013 using 2000 as the baseperiod.

Determine a value index for 2013 using 2000 as the baseperiod.