Use assembly to make a new program. At the beginning of the program, initialize the stack pointer using the SEG$\_$END$\_$SSTACK variable generated by the linker file. Load the registers with the following values:

Accumulator $A=$$$11$

Accumulator $B=$$$22$

Index Register $x=$$$3333$

Index Register $Y=$$$4444$

After the registers have been loaded with the values above, call a subroutine. In this subroutine, push the registers onto the stack in the order that they are loaded above. Clear all the registers. Pull the values back from the stack in the opposite order they were pulled.

When running the program in the debugger, go to the location of the stack pointer in the memory window and single step through the program. Fill out the corresponding stack frame below.

$\backslash$table$[[$Stack Address,Byte Data$],[,],[,],[,],[,],[,],[,],[,],[,],[,]]$