use C not C++ please. make it short

n anemometer is used to measure wind speed. Assume that you are using the Freedom KL46Z to interface with an anemometer via the analog-to-digital system. The anemometer produces an analog output which is 1V per each 40 mph of wind. What is the smallest increment of wind speed (mph) which can be measured by the KL46Z? What is the highest windspeed (mph) which can safely be measured by the KLA6Z without exceeding the voltage limits of its analog-to-digital system? What is the 16-bit sample value for wind blowing at 25 mph? Write a short program to sample the wind speed in mph and output it via the default serial console (e.g. "Serial pc(USBTX, USBRX)") approximately once per second. If the wind is faster than 50 mph, then output a logic high on PTC8. . n anemometer is used to measure wind speed. Assume that you are using the Freedom KL46Z to interface with an anemometer via the analog-to-digital system. The anemometer produces an analog output which is 1V per each 40 mph of wind. What is the smallest increment of wind speed (mph) which can be measured by the KL46Z? What is the highest windspeed (mph) which can safely be measured by the KLA6Z without exceeding the voltage limits of its analog-to-digital system? What is the 16-bit sample value for wind blowing at 25 mph? Write a short program to sample the wind speed in mph and output it via the default serial console (e.g. "Serial pc(USBTX, USBRX)") approximately once per second. If the wind is faster than 50 mph, then output a logic high on PTC8