Use the data below to answer the question "Calculate Standard Times" (you will not provide your answer in this section, but you will in the questions that follow)

A time study was performed on a process that consists of the following elements: operator removes a machined part from a milling machine (and sets it on an inspection bench), the operator then adjusts machine for the next milling cycle, loads the machine with the next part and starts an automatic cycle, and finally inspects the previously completed part (while the machine is running. Times are in minutes. Note the observed time has already been calculated into a "normal time" NT, so no performance ratings are given or necessary. Allowance %'s for each element are provided in the table.

In the "Calculate Standard Times" group of questions, you will enter the standard time calculated for each of the 4 elements from the table below.

Element & Description	1	2	3	4
	Remove machined part	Adjust machine for next cycle	Load machine with next part, start automatic cycle	inspect machined part
Cycle	NT	NT	NT	NT
1	0.32	1.18	0.23	0.96
2	0.46	1.08	0.30	1.00
3	0.38	0.88	0.27	0.89
4	0.34	1.00	0.30	0.87
5	0.36	1.19	0.25	0.59
6	0.32	1.16	0.25	0.97
7	0.32	0.96	0.30	0.81
8	0.40	1.16	0.27	0.70
9	0.36	1.04	0.33	0.97
10	0.36	1.29	0.30	0.76
Summary
Total NT
Number of Cycles	10.0	10.0	10.0	10.0
Average NT
% Allowance	10.0	12.0	12.0	12.0
Elemental Standard time

Enter the standard time for Removed Machine Part:

Enter the standard time for Load machine with next part, start automatic cycle:

Enter the standard time for: Inspect Machined Part:

Enter the standard time for Adjust Machine for Next Cycle: