Use this to complete the form for me Test 1: It is time to start testing the air. First will use a Q-Trak Indoor Air Quality Monitor model 7565 to test for temperature, carbon monoxide, and carbon dioxide. General Air Quality Results Sheet Test 2: Next you will use an Assay Technology 566 Organic Vapor Monitor to test for volatile organic compounds. You hung the VOC monitor for 15 minutes in room 370 and asked the lab for a 36-compound analysis. The passive monitors must be sent to the lab for analysis. Fill out an air sampling chain of custody form. VOC Results Sheet. Test 3: You collect two mold tape samples one on the ceiling tile in the 350 restroom and one in the 370 restroom. Fill out a mold sampling chain of custody form. Test 4: You collect one mold swab sample from the vent in room 370. Add this sample information to the mold sampling chain of custody used for Test 3. Test 5: You collect two mold air samples using a spore trap connected to a pump. The pump is calibrated at 15 liters per minute, and you collect a five-minute sample. One sample each is collected in room 370 and outside. Add this sample information to the mold sampling chain of custody used for Tests 3 and 4. Test 6: Your final sample is for viable mold spores. A biocassete is connected to a high-flow Gast pump that is calibrated to 28.3 liters per minute and a five-minute sample is collected in room 370. Add this sample information to the mold sampling chain of custody used for Tests 3, 4, and 5. Sample results from tests 3, 4, 5, and 6, are found on the Mold Results Sheet