Using the DE-Goodman criteria and a design factor of 1.5, calculate the diameter based on the...

Transcribed Image Text:

Using the DE-Goodman criteria and a design factor of 1.5, calculate the diameter based on the shaft's loadings and your guess for the shaft's diameter at the critical location, what is the shaft diameter and what is the factor of safety against yielding? Assume the notch radius to be 0.50 mm. (You must provide an answer before moving to the next part.) The shaft diameter is mm. The factor of safety against yielding is Use the general shaft layout given and determine the critical diameters of the shaft based on infinite fatigue life with a design factor of 1.5. Check for yielding. Check the slopes at the bearings for satisfaction of the recommended limits in Table 7-2. Assume that the deflections for the pulleys are not likely to be critical. Use the following shaft layout assuming a pulley transmits torque through a key and a keyseat at location A to another pulley at location B. Assume the tensions in the belt at pulley Bare T1 and T2, where T2 is 15% of T1. Given: Sut = 779 MPa and Sy = 593 MPa for 1040 Q and T. NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. 250 dia. 300 45 400 45 N 300 N 150 d T 300 dia. Using the DE-Goodman criteria and a design factor of 1.5, calculate the diameter based on the shaft's loadings and your guess for the shaft's diameter at the critical location, what is the shaft diameter and what is the factor of safety against yielding? Assume the notch radius to be 0.50 mm. (You must provide an answer before moving to the next part.) The shaft diameter is mm. The factor of safety against yielding is Use the general shaft layout given and determine the critical diameters of the shaft based on infinite fatigue life with a design factor of 1.5. Check for yielding. Check the slopes at the bearings for satisfaction of the recommended limits in Table 7-2. Assume that the deflections for the pulleys are not likely to be critical. Use the following shaft layout assuming a pulley transmits torque through a key and a keyseat at location A to another pulley at location B. Assume the tensions in the belt at pulley Bare T1 and T2, where T2 is 15% of T1. Given: Sut = 779 MPa and Sy = 593 MPa for 1040 Q and T. NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. 250 dia. 300 45 400 45 N 300 N 150 d T 300 dia.