Using the provided DAQ VI$$s$,$ write a LabVIEW program that can be used to calibrate a $60$ mm potentiometer. The user interface should include a numeric control for the operator to enter the slider position of the potentiometer in inches. The interface should have an XY graph and two dimensional array appended with distance of slider and output voltage from the potentiometer and will grow in size $($rows$)$ only when the load cell has been pressed and held with at least $3$ lbs$.($not to exceed $50\%$ of the nominal$)$ Calculated nominal sensitivity with units of volts$/$lb$.$ Wire CH$0$ of the USB $6001$ to the potentiometer and CH$1$ to the provided load cell respectively. Use dialog boxes and timers as appropriate. The loop should continuously execute but and will terminate if a stop button is pushed or if a minimum of $7$ data points are entered. Apply a trend line to the calibration data and have the user interface show the trend coefficients and correlation coefficient if possible. Finally compare and show the percent difference of the nominal and experimental sensitivities$.$