Question: Values for dimensions on the figure are given in the following table. Note the figure may not be to scale. Variable Value Variable Value


Values for dimensions on the figure are given in the following table. Note the figure may not be to scale. Variable Value Variable Value 10 in h1 8.5 in W1 h2 18.2 in 6.9 in W2 12.2 in h3 17.3 in W3 h 12.1 in 6.6 in W4 h5 4.7 in W5 13.9 in rBE = + ) inches IBE has magnitude TBE = points at an angle of horizontal. BE inches and degrees CCW from rGH = GH has magnitude TGH points at an angle of horizontal. = 12 + ) inches inches and degrees CCW from h Consider the four bar suspension linkage shown in the figure. Use the given dimensions from the table below to write the > position vector BE describing the lowest link and the position vector rGH describing the shock. Express each vector in Cartesian components and also as a magnitude and an angle (measured counterclockwise from an x-axis defined parallel to the ground and pointing right). THAWAVE D F W4 W W, W3 Ws hs h h CC) BY NC SA 2013 Michael Swanbom Values for dimensions on the figure are given in the following table. Note the figure may not be to scale. Variable Value Variable Value 10 in h1 8.5 in W1 6.9 in h2 18.2 in W2 h3 17.3 in 12.2 in W3 h 12.1 in 6.6 in W4 h5 4.7 in W5 13.9 in rBE = TBE has magnitude TBE = points at an angle of horizontal. + ) inches inches and degrees CCW from
Step by Step Solution
There are 3 Steps involved in it
StepbyStep Solution Step 1 Understanding the Geometric Setup The given figure represents a suspension system with labeled points B E G and H We need t... View full answer
Get step-by-step solutions from verified subject matter experts
