Question: What does a switch do when it receives an ethernet frame with a destination MAC address that is not found in the table it uses

What does a switch do when it receives an ethernet frame with a destination MAC address that
is not found in the table it uses to route incoming ethernet frames to the correct destination
port?

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Databases Questions!

Q:

What will a Cisco LAN switch do if it receives an incoming frame and the destination MAC address is not listed in the MAC address table? Drop the frame. Send the frame to the default gateway address....

Q:

A switch receives a frame with a destination MAC address that is not found in its MAC address table. What happens next? answer The frame is rejected and returned to the source host. The frame is...

Q:

A switch receives a frame with a destination MAC address that is not found in its MAC address table. What happens next?

Q:

what happen if a network switch receives a frame with a destination mac address not found in its switching table

Q:

what happen if a network switch receives a frame with a destination mac address not found in its switching table

Q:

6. What is true concerning physical and logical topologies? a. The logical topology is always the same as the physical topology. b. Physical topologies are concerned with how a network transfers...

Q:

Question 31 (1 point) What is the general term that is used to describe a piece of data at any layer of a networking model? O packet segment O protocol data unit frame Question 32 (1 point) What...

Q:

17 Which of the following is/are true about how Layer 2 Ethernet switches make forwarding (switching) decisions: (Select all that apply) Switches examine the Destination MAC address in a Layer 2...

Q:

Ethernet Basics 1. What was the original maximum data transfer rate of the first Ethernet developed by Xerox? A. 3 Mbps B. 10 Mbps C. 16 Mbps D. 56 Kbps 2. Which company was involved in the 1979...

Q:

How does routing work? Routers refer to internal routing tables to make decisions about how to route packets along network paths. A routing table records the paths that packets should take to reach...

Q:

Bonds Issued at a Discount (Effective Interest) Sicily Corporation issued $1,050,000 in 5% bonds (payable on December 31, 2032) on December 31, 2022, for $955,500. Interest is paid on June 30 and...

Q:

Using the conservation laws, demonstrate that the total mechanical energy of a planet of mass m moving around the Sun along an ellipse depends only on its semi-major axis a. Find this energy as a...

Q:

Which two of the following are differences between common stock and preferred stock? Check All That Apply Common stockholders have priority over preferred stockholders in receiving dividends.Common...

Q:

From Figure 1, which ones can be used as the part of DNA? There are multiple answers. A B C D E F G H FIGURE 1

Q:

What would be the shared Data Elements between Position Control and Salary Grade Tables in providing cost input to Budgets for vacant positions?

Q:

What is the purpose of the Salary Structure Table?

Q:

What is the scope and use of a Job Family Table?