Question: What does INPUT _ PULLUP do in Arduino Sets pin as high impedance a Configures an output pin.b Configures pin for PWM C Activates an

What does INPUT_PULLUP do in Arduino
Sets pin as high impedance a
Configures an output pin.b
Configures pin for PWM C
Activates an internal pull-up resistor.d

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

UNO digital pins 0 to 7 are connected to Port D of the ATmega328 microcontroller while digital pins 8 to 13 are to Port B. You are to implement a function whose functionality is similar to pinMode()....

Q:

/ / Hardware: One button with GPIO pullup resistor. / / One Green LED with 3 3 0 Ohm resistors. / / One Red LED with 3 3 0 Ohm resistors. / / The LCD with variable resistor to control brightness of...

Q:

I need help fixing the above code to do the following, 2 push buttons A, B A will increment frequency of sound B will decrement frequency of sound gradually. sketch nov08a int speaker 5; int buttonA...

Q:

You will create a millisecond delay using Timer 0 to control the rate at which several LEDs blink. These LEDs will represent a binary number and will count up continuously to 15. A switch will toggle...

Q:

Need to create state an ISR for this project. The micro-controller is the ATmega2560. Create state an ISR for this project. The micro-controller is the ATmega2560. This program must compile. This can...

Q:

Have to initialize timer0 (with function initTimer0()). The micro-controller is the ATmega2560. The program must compile. This can be tested using the check mark icon. The project must be pushed to...

Q:

Have to find the function initTimer0()) and the delayMs(unsigned int delay). The micro-controller is the ATmega2560. Overall The program must compile. This can be tested using the checkmark icon. The...

Q:

Have to find the function initTimer0()) and the delayMs(unsigned int delay). The micro-controller is the ATmega2560. The program must compile. This can be tested using the checkmark icon. The project...

Q:

Need to create state machine for this project given these constraints. The micro-controller is the ATmega2560. This program must compile. This can be tested using the checkmark icon. The project must...

Q:

You will create a millisecond delay using Timer 0 to control the rate at which several LEDs blink. These LEDs will represent a binary number and will count up continuously to 15. A switch will toggle...

Q:

Ernie Jameson is a design engineer with a proven track record in the field of electronic musical instruments. He recently designed a new VLSI (very large scale integrated) chip. This chip is meant to...

Q:

Cathay Pacific Airlines (CHN) reported the following for 2009 (in millions) Service cost ............................................HK$316 Interest on...

Q:

explain the difference between operating revenues / expenses and nonoperating revenues / expenses . Why does the GASB require that operating revenues / expenses be reported separately on proprietary...

Q:

13 Required information [The following information applies to the questions displayed below.] Evergreen County acts as the disbursing agent for a state grant for the performing arts. The state is...