Question: What does the Vin connection used for? A . It is at the same voltage level as the connected power. B . It is another

What does the Vin connection used for?
A. It is at the same voltage level as the connected power.
B. It is another connection which passes through the regulated power on the Arduino.
C. It allows a +5VDC source to be connected to the Aruduino for power.
D. It allows for additional current input to run extra device.

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

Experiment 5: Using an Oscilloscope The purpose of this experiment is to familiarize you with the myDAQ oscilloscope. The oscilloscope is the most complicated instrument in a typical Electrical...

Q:

WHEATSTONE BRIDGE DATA SHEET igital Multi-meter readings and theoretical values Introduction The Wheatstone bridge is an electrical circuit used to compare an unknown resistance with a known...

Q:

LAB PROJECT: DIODES, DC and AC applications mer:091718 REPORT A written report will be required based on the information you acquire in this lab. The lab will count for one grade and the report will...

Q:

With a particular number of towers the chances of incidence of lightning on power conductor scan be minimized by placing a ground wire at the top of the tower structure.. The tower presents a...

Q:

This streamer is very intense where the current varies between 1000 amps and 200,000 amps and the speed is about 10% that of light. With a particular number of towers the chances of incidence of...

Q:

The value of Io should not be too small or large so that the relay is either too sensitive or slow in responding. Damage to the equipment due to abnormally large and unbalanced currents and low...

Q:

In case of an over current relay, mathematically this can be defined as the ratio between the short circuit fault current (Is) and The relay operating current (Io). The value of Io should not be too...

Q:

The sensitivity of a relay refers to the smallest value of the actuating quantity at which the relay operates detecting any abnormal condition. In case of an over current relay, mathematically this...

Q:

The relay operating current (Io). The value of Io should not be too small or large so that the relay is either too sensitive or slow in responding. Damage to the equipment due to abnormally large and...

Q:

Explosions may occur in the equipments which have insulating oil, particularly during short circuits. This may result in fire and hazardous conditions to personnel and equipments Individual...

Q:

Intercontinental Chemical Company, located in Buenos Aires, Argentina, recently received an order for a product it does not normally produce. Since the company has excess production capacity,...

Q:

On April 8, one week before the first internal project review is scheduled to take place, Spencer Tracey and Margaret Porter are reviewing the presentation that Spencer intends to make to their vice...

Q:

Which of the following terms best describes the types of the audit procedures the auditor will perform? a . Nature of detection risk. b . Nature of auditing procedures. c . Material misstatement...

Q:

During May, Sharpton Corporation recorded the following: Raw materials, beginning balance Work in process, beginning balance Finished Goods, beginning balance Transactions: (1) Raw materials...