What is the smallest possible allowable cross sectional area for face $3$ when viewed in the front view?

Units are in$^2.$

Enter four digits after the decimal point.

Question $6$

A part has been built. The diameter of hole $5$ is measured as $0\mathrm{.}350".$ The perpendicular distance of the center of the hole from datum A is measured as $\backslash (0\mathrm{.}994^\{\backslash$prime $\backslash$prime$\}\backslash ).$ What is the largest distance that the center of hole $5$ can deviate from the 'perfect' location in the horizontal direction as viewed in the top view?

Enter four digits after the decimal point.

Question $7$

What is the position tolerance of hole $1$ if it is made with a diameter of $\mathrm{.}355$ inches?

Enter three digits after the decimal point. $1)$ Units are in inches.

$2)$ Hididen lines are not shown in the top view.