When installing simple single source low voltage series/parallel DC circuit on a pre drilled fiberglass solder board, what technique would you typically use to connect the wires/conductors in the circuit? Question 20Select one: Insert the wires/conductors into the pre-drilled holes and loop-in and out between connection points to keep in place and create a pathway to complete the circuit. Insert the wires/conductors into the pre-drilled holes so that they make contact with the connection points and solder the connection point to keep in place and complete the circuit. Insert the wires/conductors into the pre-drilled holes so that they make contact with the connection points and wrap around to keep in place. Insert the wires/conductors into the pre-drilled holes and solder a pathway between connection points to keep in place and complete the circuit