Question: when you connect a PC to a layer 2 switch port , what should be the switch port mode? access port Trunk port blocked port

when you connect a PC to a layer 2 switch port , what should be the switch port mode?
access port
Trunk port
blocked port
designated port

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Databases Questions!

Q:

Q:1 Refer to the exhibit. How many broadcast domains are displayed? a) 1 b) 4 c) 8 d) 16 e) 55 Refer to the exhibit. How is a frame sent from PCA forwarded to PCC if the MAC address table on switch...

Q:

Refer to the exhibit. How is a frame sent from PCA forwarded to PCC if the MAC address table on switch SW1 is empty? Question 4 options: a) SW1 floods the frame on all ports on SW1, excluding the...

Q:

15 Hosts 20 Hosts Refer to the exhibit. How many broadcast domains are displayed? a) b) c) d) e) 16 ATC-52#show port-security Interface fastethernet 0/3 Port Security Port Status Violation Mode Aging...

Q:

From the output of the following IOS command, what conclusion can you have based on the command's output?Select one: a . The port has the maximum number of MAC addresses that is supported by a Layer...

Q:

Follow the submission instructions for each exercise and ensure that you meet the deadline, use the correct submission process and submit your work to the correct place. For some laboratory tasks you...

Q:

Topology Note: Do not use 2960 switches. You must select the 3560 model switch in Packet Tracer as shown below. 2960s will not support IPv6 in Packet Tracer. Assessment Objectives Part 1: Configure...

Q:

Topology Note: Do not use 2960 switches. You must select the 3560 model switch in Packet Tracer as shown below. 2960s will not support IPv6 in Packet Tracer. Assessment Objectives Part 1: Configure...

Q:

Question 1 4 pts (TCO 3) The TCP/IP _____ layer is the equivalent of the OSI layer(s) _____. Internet; data link network access; data link and physical session; application application; application...

Q:

Networking / Computer Communications: Refer to Figure 3.19a. Assuming that the network address is 192.168.1.x, explain the entries 192.168.1.255 ff-ff-ff-ff-ff-ff and 255.255.255.255...

Q:

Please help... Due in 3 hours Your task in this Assignment I) Use IP Address 10.0.0.0 as IP Address for the entire High-Tech Organization II) Decide on the subnet number based on the above IP Address...

Q:

Explain the difference between (OLAP) and (OLTP).

Q:

Consider a one-dimensional ideal gas consisting of N = 5 particles each of which has the same speed v, but can move in one of two directions with equal probability. The velocity of each particle is...

Q:

All of the following product descriptions may be used in an advertisement for variable products, EXCEPT: QID: 1932676Mark For Review A Golden Age Variable Life Policy B Gainsmaker Variable Annuity C...

Q:

Sup Fend Superior Fender, which uses a standard cost system, manufactured 20,000 boat fonders during 2024, using 142,000 square foet of extruded vinyl purchased at $1.10 per square foot. Production...

Q:

1. Why are benefits strategically important to employers, and what are some key strategic considerations?

Q:

LO1 Understand risk management and identify its components.

Q:

2. If you were to use technology to assist with communicating about benefits, how would you approach doing it? What are the potential challenges associated with your strategy?