Question: Which Cisco IOS switch command is used to configure the use of LACP on an interface? etherchannel - group group - num lacp - group

Which Cisco IOS switch command is used to configure the use of LACP on an interface?
etherchannel-group group-num
lacp-group group-num mode mode
lacp number mode mode
channel-group group-num mode mode
Which Cisco IOS switch command is used to configure the use of LACP on an interface?
etherchannel-group group-num
lacp-group group-num mode mode
lacp number mode mode
channel-group group-num mode mode
Which Cisco IOS switch command is used to

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Programming Questions!

Q:

Lab 1: Introduction to Packet Tracer Lab 1: Introduction to Packet Tracer Total Marks= 10 Objectives of this Lab: The goal of this lab is to become familiar with building topologies in Packet Tracer...

Q:

Topology Note: Do not use 2960 switches. You must select the 3560 model switch in Packet Tracer as shown below. 2960s will not support IPv6 in Packet Tracer. Assessment Objectives Part 1: Configure...

Q:

Topology Note: Do not use 2960 switches. You must select the 3560 model switch in Packet Tracer as shown below. 2960s will not support IPv6 in Packet Tracer. Assessment Objectives Part 1: Configure...

Q:

The router commands used to configure and enable the FastEthernet 0 / 1 router interface with the IP address of 1 0 . 1 0 . 2 0 . 2 5 0 and a subnet mask of 2 5 5 . 2 5 5 . 0 . 0 are: Router# conf t...

Q:

cisco packet tracer 1 / 9 100% + Laboratory Project II IOS Networking Essentials This laboratory project introduces students to simple iOS networking tasks such as interface configuration, DHCP,...

Q:

3 / 9 100% + Objective II: Study serial defaults Enter a command on Router that reports the status and parameters of the interface Serial0/0/0. What's the interface's Physical and Data Link layers'...

Q:

need help with the commands used to answer question 7 a b and 8 a-c on a cisco router and switch use topology table for guidence. packet tracer. Addressing Table P eter Area Subot Mask Default...

Q:

Labrouter are precontigured. Connection to Labnetwork is through K J J connectors named Labnetwork Configure Rx:s fa 0 / 0 interface with ip address of 1 0 . 9 5 . 0 5 , where x is the pod number (...

Q:

Question 5: (30 marks) 192.168.15.024 VLAN 15 P04 PC3 PC PCI IT 11 111 !!!! 600 SIY RI PCS PC6 PCS PCZ VLAN 25 Figure 1 To answer this question you should Configure the devices (switch and router) on...

Q:

need help with question five and the commands needed to excute each sub question for cisco switch use topology and table for guidence on the question. packet tracer Areg 1 u. 2. LE semulated...

Q:

If you were a salesperson for Ford for their large trucks and you had the territory for Ontario, Canada how might you identify leads and qualify them? What specifically would you use? Why would you...

Q:

The U.S. Bureau of Reclamation is considering a project to extend irrigation canals into a desert area. The initial cost of the project is expected to be $1.5 million, with annual maintenance costs...

Q:

Is this a correct option? Taxpayer's child is a 6 - year - old child model for department stores. Child earned \ ( \ $ 5 , 9 0 0 \ ) for the year. Taxpayer is allowed to open a Roth IRA for child and...

Q:

Find a formula for this function 05 0 1 y co COS 2 T 1 3 x D L Find a formula for this function. .12 2 IT ? Icos