Write a CNC program to direct the required machining operations given in the table below for the part shown in the figure. Wofi Position and Movement Conmand. A G81 (Drilling - Spot Boring) commend is written in CNC program, the position of the lillet in respect to the tool must be specified using the table below. the following format: GBO){G98ororor{G91)G99} please refer to page 52 for the variable definitions. The two diagrams below illustrate the direction of compensation coces G41 and G42. in relation to ycu eye level. G41. LeFT Hand G42 - RIGHT HaND Sequence of moves: Op 1) Rapid position to X,Y and Z (the Initial level). Op 2) Rapid traverse to R point level. Op 3) Feed to Z depth. Op 4) Rapid traverse to Initial level \{G98) or R point level (G99). Write a CNC program to direct the required machining operations given in the table below for the part shown in the figure. Wofi Position and Movement Conmand. A G81 (Drilling - Spot Boring) commend is written in CNC program, the position of the lillet in respect to the tool must be specified using the table below. the following format: GBO){G98ororor{G91)G99} please refer to page 52 for the variable definitions. The two diagrams below illustrate the direction of compensation coces G41 and G42. in relation to ycu eye level. G41. LeFT Hand G42 - RIGHT HaND Sequence of moves: Op 1) Rapid position to X,Y and Z (the Initial level). Op 2) Rapid traverse to R point level. Op 3) Feed to Z depth. Op 4) Rapid traverse to Initial level \{G98) or R point level (G99)