Question: Write an 8051 C program that will make an LED which is connected at P2.2 to blink continuously every 1 second.

Write an 8051 C program that will make an LED which is

connected at P2.2 to blink continuously every 1 second.

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Databases Questions!

Q:

Write an 8051 C program that will make an LED which is connected at P3.1 to turn on for 2 seconds and turn off also for 2 second repeatedly.

Q:

8 LEds are connected at all of the pins of port P3 . Write an 8051 C program that will make the 8 LEDs to toggle continuously every 100ms in this way: (3 Marks) ON OFF OFF ON ON ON ON OFF OFF ON ON...

Q:

A Red LED is connected at P2.2, a Green LED at P2.4 and a switch at P3.1. Write an 8051 C program that will blink the red LED every 500ms when the switch is OFF and will blink the green LED every...

Q:

Q2. Three LEDs, colored as red, blue and green are connected at P1.2,P1.4, and P1.6 respectively. Two switches are connected at P2.4, and P2.5. A buzzer is connected at P1.8. Write an 8051 C program...

Q:

I need full answer for this question in C language. raw the circuit diagram and write the 8051 C program that will simulate a simple traffic light using green LED, orange LED and red LED connected to...

Q:

I need full answer for this question. raw the circuit diagram and write the 8051 C program that will simulate a simple traffic light using green LED, orange LED and red LED connected to the pins...

Q:

I need full answer for this question. raw the circuit diagram and write the 8051 C program that will simulate a simple traffic light using green LED, orange LED and red LED connected to the pins...

Q:

Computer Architecture and Organization Introduction to the Arduino Microcomputer Equipment: Arduino UNO microcomputer, PC with Arduino IDE installed, and a USB cable. Prototyping components and...

Q:

6. Write a complete C program to do the following: 1. Setup TimerA_0 in UP mode to generate a periodic interrupt every 125 ms. 2. In the TA0 interrupt service routine (ISR), control P1.0 (LED...

Q:

with 8051 microcontroller assembly language Q2. Write a program using interrupts to get data serially and send it to P2 while Timer-O is turning the LED connected P1.6 on and off every second

Q:

How much energy (in KJ) is available for sustaining muscular and nervous activity from the combustion of 1.0 mole of glucose molecules under standard conditions at 37C (body temperature)? The...

Q:

Using Table 16-5, plot the relationship between the glass-transition temperatures and the melting temperatures of the addition thermoplastics. What is the approximate relationship between these two...

Q:

P5.14 (LO 4, 5) (Expected Cash Flows and Present Value) At the end of 2025, Sawyer SE is conducting an impairment test and needs to develop a fair value estimate for machinery used in its...

Q:

Given the following wormation calculate the estimated trut-year net operating income NON for this offon bulding using above-the-ne treatment of capital pemand auming no microun Income Lot 1.1 acres...

Q:

2. Review the index of wage rates of 1980, 1990, 1998, 2002, and 2005 and determine whether the strategy and decision in 2008 would be the same as in the previous years. You are the owner of a small...

Q:

1. Identify six imperatives for studying intercultural communication.

Q:

4. You be the arbitrator. How will you rule? Give your reasoning. At the Coral Gables VA Medical Center, the position for Gardener Leader PD#086550, WL-5003-08, Engineering & Construction Dept. FAC...