Question: Write an AVR C program using Timer 1 interrupt to create a square wave of 1Hz on pin PB7 while sending data from PORTC

Write an AVR C program using Timer 1 interrupt to create a square wave of 1Hz on pin PB7 while sending data 

Write an AVR C program using Timer 1 interrupt to create a square wave of 1Hz on pin PB7 while sending data from PORTC to PORTD. Assume XTAL=8MHz. Problem 2 Assume that the INTO pin is connected to a switch. Write an AVR C program in which it goes high, the content of PORTC increases by one. Problem 3 Using pin change interrupt, write an AVR C program that sends the value of PORTC to PORTD whenever the value of PORTC changes. Problem 4 Assume that Timer 1 is programmed for CTC mode, TCNT1=$0001, OCR1A = $F501 and OCIE1A bit is enabled. Explain how the interrupt is activated. Problem 5 Assume that Timer 1 is programmed for Normal mode, TCNT1=$E8FF, TOIE1 bit is enabled. Explain how the interrupt is activated. Problem 6 Explain the role of INTFO and INTO in executing external interrupt 0. Problem 7 Explain the difference between low-level and falling edge - triggered

Step by Step Solution

3.44 Rating (160 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock

Sure lets go through each problem one by one include include define FCPU 8000000UL void timer1init TCCR1B 1 CS12 1 WGM12 Set prescaler to 256 and CTC ... View full answer

blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Programming Questions!