Write down the IP address and the subnet mask for each of the following routers/devices. As an example, R2-0 IP address and subnet mask should be 1.1.1.1/16. You can choose any random host address. The only constraint that it must be within the host addresses range. For example, I choose 1.1.1.1 for R2-0, someone else may choose 1.1.1.5 and both of them are correct. This corresponds to setting up the IP addresses for your subnets manaually (30 points). Suppose that you want to avoid all the hassle of configuring all the IPs on a certain subnet manually (including any newly added devices in future), what should you do? (10 points) For the figure below; We have 7 different subnets (A,B,C,D,E,F,G),6 routers (R1, R2, R3, R4,R5, and R6), and 2 hosts ( H1 and H2 ). We also assume that there are many hosts attached to each subnet but are not shown to preserve the figure simplicity