Write program that will accomplish the desired tasks listed below, using few lines of code as possible.

Make sure to show memory and register values after each question below.

Define Data1 and Data2 in the data segment at offset 100h and 400h and store the following values in them:

Data1 DB 20h, 30h, 40h, 1Fh

Data2 DB 10h, 2Ah, 55h, 33h

Use the register indirect addressing mode to initialize the content of memory location labeled Data1 at offset 100h by the value 1001H.

Use the based index addressing mode to move into register CX the content of the memory location at offset 402h and 403h.

Use indexed addressing mode to move the contents of register CX into memory location starting at offset 101h.

continuo the code below

.386 .model flat, stdcall .stack 4096 ExitProcess proto, dwExitCode:dword .data .code main proc call ExitProcess main endp end main