Write the MIPS code to place the following variables into the indicated MIPS registers. Place the code in the last column of the table. Load the address of the variable specified into the designated register Instruction to load address Variable MIPs Register $t3 Ss1 St3 Write the MIPS code to load the indicted variable values into the specified MIPs registers. Place the code in the last column of the table. Assume the variable memory addresses are in the registers from the previous table. Load the value in memory specified by the address in the Variable register into the specified MIPs register (eg in the first row $s0 gets the value in memory location specified by $t3) Variable MIPs Register A St3 Instruction to load value $s0 $s4 $t3 Write MIPS code to perform these operations (Use register names in you code, not pseudocode). Again assume the registers have been loaded according to the previous tables Variable Instruction to perform operation