You are required to design and implement (using Proteus) an embedded system of your choice. You have to document your work in a professional report. Your report must have the following sections: Abstract This section should be a couple of lines describing what your project does. 1. Introduction Include: background, problem statement and general overview 2. Hardware Design Discuss your hardware design here. Show detailed schematics, and the interface here. 3. Hardware Interface In this section, you can describe how your hardware communicates, such as which buses or protocols were used. 4. Software Design Show your software design. Show the tasks that you are using, and what they are doing at a high level. Do not show any code, but you may show pseudo-codes. Keep in mind that you are showing DESIGN of your software, not the inner workings of it. 5. Implementation This section includes implementation, but again, not the details, just the high level. For example, you can list the steps it takes to communicate over a sensor, or the steps needed to write a page of memory onto SPI Flash. You can include sub-sections for each of your component implementation. 6. Conclusion Conclude your project here. You should address the "so what" part here to indicate what you ultimately learnt from this project. How has this project increased your knowledge