You may have to use global variables to hold the constants needed for the arithmetic.

Required:

The temperature conversion procedures must be in a separate asm file called conversion.asm. This means you should have main.asm and conversion.asm. You can use constant values in the data segment of conversion.asm but you MUST pass the temperature to be converted to the procedure through the floating point stack and return the converted value back to main on the floating points stack.

You can format these as you normally do and paste them one after the other in the submissions box.

NOTE:

Legacy data directives like DB, DW, DD, DQ, and DT are not allowed. You will receive a 30% reduction in grade for using them.

You are not to use any .IF .ELSE, .WHILE, or .ENDW instructions. You are to use pure old fashion assembly language to solve this.

You must comment every line of code you write or your grade will be reduced 20%