You will first design the power transmission system for a single speed bandsaw to be used for cutting wood and plastic only. Since wood and plastic are soft materials, a high cutting blade speed can be used. You will need to choose the appropriate radii of Pulley 1 and Pulley 2 to meet the below design Specifications and to obtain the desired blade speed. A block diagram of the bandsaw design is shown in Figure 2. Show all of your work on the next page and then fill out Table 1 that documents your results. As you carry out your analysis, be carful with units and make note if a radius or diameter is given. As a US company we will be using inches and feet units. Single Speed Design Specs: 0 ldlerfDriye Wheel Diameter: 26 inches 0 Motor Speed: 1225 RPM ' Desired Blade Speed: 2200 i 100 FPM (feet per minute] 0 Available pulleys have diameters ranging between 1 inch and 20 inches. They are available in half inch size increments {1.0", 1.5\