Question: Air flows into a diffuser at 300 m/s, 300 K and 100 kPa. At the exit the velocity is very small but the pressure is

Air flows into a diffuser at 300 m/s, 300 K and 100 kPa. At the exit the velocity is very small but the pressure is high. Find the exit temperature assuming zero heat transfer.

Step by Step Solution

★★★★★

3.61 Rating (169 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

From the steady flow energy equation h 1 v 1 2 2gz 1 h ... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Document Format (1 attachment)

774-P-T-F-L (967).docx

120 KBs Word File

Students Have Also Explored These Related Thermodynamics Questions!

Air at 15oC and 100 kPa enters the diffuser of a jet engine steadily with a velocity of 100 m/s. The inlet area is 0.2 m2. Determine (a) The mass flow rate of the air (m). (b) What-if Scenario: What...

Air is compressed from 400 K and 100 kPa in an isentropic process. Assuming constant specific heats from Table B-2 and variable specific heats, calculate the final temperature if the final pressure...

Air flows into a heat engine at ambient conditions 100 kPa, 300 K, as shown in Fig. P10.79. Energy is supplied as 1200 kJ per kg air from a 1500 K source and in some part of the process a heat...

Air flows into a diffuser at 300 m/s, 300 K and 100 kPa. At the exit the velocity is very small but the pressure is high. Find the exit temperature assuming zero heat transfer.

Air is accelerated through an adiabatic nozzle with initial temperature of 4 7 5 K and an initial pressure of 1 3 0 kPa . Air exits the nozzle at approximately atmospheric pressure ( 1 0 0 kPa . ) If...

Hydrogen ( H 2 ) flows in a constant - area duct with a 3 - cm diameter and a length of 2 5 cm . If the initial velocity is 2 5 0 0 m / s , and the Darcy friction factor is 0 . 0 2 4 , find the exit...

A horizontal diffuser operating at steady state is used to slow the flow of CO 2 . The inlet volumetric flow rate is 1 0 m 3 / s , and the inlet temperature and pressure are 6 0 0 K and 2 0 0 kPa,...

Air enters a diffuser with a velocity of 200 m/s, a static pressure of 80 kPa and a temperature of 268 K. The velocity leaving the diffuser is 50 m/s and the static pressure at the diffuser exit is...

As shown in the figure below, air enters the diffuser of a jet engine at 1 8 kPa, T 1 = 2 5 0 K with a velocity of V 1 = 2 3 3 m s , all data corresponding to high - altitude flight. The air flows...

ME 2 3 4 Fall 2 0 2 3 Final Exam Problem 3 ( 2 0 pts; Show your work for partial credits ) As shown in figure, air enters the diffuser of a jet engine at 1 8 kPa, 2 1 6 K with a velocity of 2 6 5 m s...

Moritz, a guest at Pines Hotel, was sitting in the lobby when Brown, a hotel employee, dropped a heavy vacuum cleaner on her knee. When Moritz complained, the employee insulted her and hit her with...

How should the audit be adjusted when the auditor has identified a high risk of fraud occurring?

A . as reductions of the related asset or liability accounts. B . as a current amount. C . as either noncurrent or current. D . as a noncurrent amount.

Samson Apartments, Inc., has a large number of units. A concern of management is the number of vacant apartments. A recent study revealed the percent of the time that a given number of apartments are...

The pressure in a container on a mountain at an elevation of 25,000 ft is measured to be a) 5 psi b) 20 psi. What is the absolute pressure in psia? In psfa?

A thermistor has a resistance of 3000 at 25C. If = 4220 K, determine its resistance at a) 60C, b) 120C, c) 180C.

The mercury thermometer of Fig. 1.22 has a 6-mm-diameter rigid sphere that holds the mercury. If the temperature increases by a) 20ºC, b) 40ºC, c) 60ºC, estimate the height the mercury...

Which of the following accounts increases with a debit ? a) Interest Payable b) Accounts Payable c) Cash d) Capital

Lockheed Corporation purchased a machine on January 2, 2020, for $4,000,000. The machine has an estimated 5-year life with no salvage value. The straight-line method of depreciation is being used for...

Asset W has an expected return of 10.6 percent and a beta of 1.40. If the risk-free rate is 3.6 percent, complete the following table for portfolios of Asset W and a risk-free asset. (Leave no cells...