Question: Block A in Fig. 8.35 has mass 1.00 kg, and block B has mass 3.00 kg. The blocks are forced together, compressing a spring S

Block A in Fig. 8.35 has mass 1.00 kg, and block B has mass 3.00 kg. The blocks are forced together, compressing a spring S between them; then the system is released from rest on a level, frictionless surface. The spring, which has negligible mass, is not fastened to either block or drops to the surface after it has expanded. Block B acquires a speed of 1.20 m/s.
(a) What is the final speed of block A?
(b) How much potential energy was soured in the compressed spring?

Block A in Fig. 8.35 has mass 1.00 kg, and block B

m,-1.00kg ms-3.00 kg

Step by Step Solution

★★★★★

3.45 Rating (171 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

IDENTIFY In part a no horizontal force implies P is constant In part b use the energy expre... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Document Format (1 attachment)

P-M-IM (206).docx

120 KBs Word File

Students Have Also Explored These Related Mechanics Questions!

2.1 Assuming that Mortgage A is selected, calculate the net present value of the investment. Use the cost of equity that you calculated in Question 1.1 as the appropriate discount rate. Round your...

In Figure a block of mass m = 12 kg is released from rest on a frictionless incline of angle = 30o. Below the block is a spring that can be compressed 2.0 cm by a force of 270 N. The block...

A 10.0-kg block is released from rest on a frictionless track inclined at an angle of 55. (a) What is the net force on the block after it is released? (b) What is the acceleration of the block? (c)...

A half cylinder of mass m is released from rest in the position shown and swings freely about the horizontal diameter AB. Determine, at this instant, (a) The acceleration of point D, (b) The...

Block A in (Figure 1) has mass 1.00 kg, and block B has mass 3.00 kg. The blocks are forced together, compressing a spring S between them; then the system is released from rest on a level,...

Block A in (Figure 1) has mass 1.10 kg , and block B has mass 2.70 kg . The blocks are forced together, compressing a spring S between them; then the system is released from rest on a level,...

Please send me answer of this question within 10 min i will give you like sure.send me typed answer only please. Block A in (Figure 1) has mass 1.10 kg , and block B Part B has mass 3.20 kg . The...

Please answer both parts What is the final speed of block A? Express your answer in meters per second. Block A in (Figure 1) has mass 1.10 kg , and block B has mass 3.05 kg . The blocks are forced...

Block A in the figure (Figure 1) has a mass of 1.00 kg, and block B has a mass of 3.00 kg The blocks are forced together, compressing a spring S between them then the system is released from rest on...

Two blocks m_A = 1 kg and m_B = 1 kg are forced together, compressing a spring between them by a distance x = 2 m; (the force constant of the spring is k = 2 N/m) then the system is released from...

5. A flywheel of mass 100 Kg and a radius of 1.5m is rotating at a rate of 300 rad/sec when a torque of - 450Nm is applied. Find the angle theta that the disk rotates through before coming to a rest....

Use the hand lengths in Exercise 1 and find the following: (a) Mean; (b) Median; (c) Standard deviation; (d) Variance; (e) Range. Include the appropriate units of measurement. 173 179 207 158 196 195...

Cumene (isopropylbenzene) is a relatively inexpensive commercially available starting material. Show how you could prepare m-isopropylnitrobenzene from cumene.

P2.23 The small-signal circuit equivalent to a commonemitter transistor amplifier is shown in Figure P2.23. The transistor amplifier includes a feedback resistor Rf. Determine the inputoutput ratio...

Homeowners Insurance - Complete 1A or 1B. 1A. If you own a home, you can list the name of the policy protecting the exposure, name of the company, premium payment, deductibles, and dollar limits for...

AAUP - JENIN) / Routh's Stability Criterion: Select one: O a. Improves the stability of a system O b. Suggests methods for improving stability Q c Restores the equilibrium of a system O d. Specifies...

a. Calculate the unknown variable for the following interest-bearing promissory note. b. Give a real-life example of a noninterest-bearing promissory note. Why would a business offer such a deal?...

Exercise 5.12 In this exercise, we will examine how replacement policies impact miss rate. Assume a two-way set-associative cache with four blocks. You may fi nd it helpful to draw a table like those...

The Snedecker Corporation is considering a change in its cash-only policy. The new terms would be net one period. The required return is 1.6 percent per period. Based on the following information,...

QUESTION 6 If the simple CAPM is valid and all portfolios are priced correctly, which of the situations below is possible? Consider each situation independently, and assume the risk-free rate is 5%....

what is a compensating control in security controls?