Question: Describe the physical origins of line widths in the absorption and emission spectra of gases, liquids, and solids.

Describe the physical origins of line widths in the absorption and emission spectra of gases, liquids, and solids.

Step by Step Solution

★★★★★

3.48 Rating (158 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock

1 Doppler broadening This contribution to the line width is due to the Doppler effect which shifts t... View full answer

blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Document Format (1 attachment)

Word file Icon

57-C-PC-S (174).docx

120 KBs Word File

Students Have Also Explored These Related Physical Chemistry Questions!

Q:

Explain the physical origins of surface activity by surfactant molecules.

Q:

Solids and liquids resist being compressed. They are not totally incompressible, but it takes large forces to compress them even slightly. If it is true that matter consists of atoms, what can you...

Q:

The adsorption of solutes on solids from liquids often follows a Freundlich isotherm. Check the applicability of this isotherm to the following data for the adsorption of acetic acid on charcoal at...

Q:

Describe the physical origins of the gross selection rules for infrared spectroscopy.

Q:

Describe the physical origins of the gross selection rules for vibrational Raman spectroscopy.

Q:

ICS Architecture Final Project Template SEC6082 Your Name Table of Contents Executive...

Q:

Unit 1: Liberalism Describe the historical origins of liberalism. What type of rule does liberalism respond to, and reject? What sorts of institutions did liberals install in place of the old,...

Q:

Problem #1 Biocompatibility. Halperin, Polymer brushes that resist adsorption of model proteins: design parameters. Langmuir, 1999, 15, 2525- 2533. a) Please explain the physical meanings of the term...

Q:

Problem 11.1 In Figure 11.24 we observe that the dj/D ratio of dispersed two-phase blends goes through a maximum at a certain critical blend ratio, and that measured values of dj/D ratio for blends...

Q:

Nitrogen trifluoride, NF 3 , boils at 129C and is a very weak Lewis base. By contrast, the lower molar mass compound NH 3 boils at 33C and is well known as a Lewis base. (a) Describe the origins of...

Q:

Average Velocity for Mass Balance in Flow Down Vertical Plate. For a layer of liquid flowing in laminar flow in the z direction down a vertical plate or surface, the velocity profile is pg8? 24 where...

Q:

A man is planning to retire in 25 years. He wishes to deposit a regular amount every three months until he retires, so that, beginning one year following his retirement, he will receive annual...

Q:

( 3 0 Points ) Vital capacity is a measure of the amount of air that someone can exhale after taking a deep breath, Data was collected on brass players and a control group. Assume the population...

Q:

QUESTION 3 For cyclohexane at State 1 (T-127 C and P-12 bar) that is cooled to its saturated vapor in State 2 at T-59 C: a. Find the change in enthalpy for cyclohexane going from State 1 to State 2...

Q:

A man borrowed money from his friend in the amount of 5,000 birr on January 15, 2018. He is obliged to pay the amount on his friends birthday on November 28 during the same year at an interest rate...

Q:

Like alkali metals, the alkaline earth metals also dissolve in liquid ammonia. Which of the following is/are correct statement(s)? 1) Be and Mg show poor reaction. II) The colour of the solution is...

Q:

Among the following hydrated ions, how many has higher ionic mobility than Be? (ag) Lit, Na, Mg: Caa) Canj: Mg Ca?+ (aq) "(aq) (ag)'

Q:

An impure gypsum of weight 200g with thermally stable and inert impurities suffer a loss of 27g on heating in order to convert all the gypsum in to plaster of Paris quantitatively. The percentage of...

Q:

Explain why a minimum of 32 tRNAs are required to translate the standard genetic code.

Q:

Many ionic compounds are considered to pack in such as way that the anions form a close-packed lattice in which the metal cations fill holes or interstitial sites left between the anions. These...

Q:

(a) If a pure element crystallizes with a primitive cubic lattice, what percentage of the unit cell is empty space? (b) How does this percentage compare with that of empty space in an fcc unit cell?...

Q:

The molar heat capacity of a substance is the heat required to raise the temperature by 1 C per mole of molecules or formula units of the substance. For a given substance, the more varieties of...

Q:

Furthe dot plot below, what is the maximum and what is the minimum entry? 0 O O O O O O O O O O O O O 12 13 14 15 1B 1? O 11. max: 14; min: 12 O B. max: 54; min: 12 O C. max: 54; min: 15 O D. max:...

Q:

Normal distribution Let 1:1,. .. ,1}, ~ MM}, 3 > u. (a) Find the mie of 5-, MLE. (12:) Find the Fisher information I09}. (1:) Find the Rab-Cramer bound for H. (d) We know 13(50): 9, where 32 = i...

Q:

Chester has an asset turnover of 1.49 (Asset Turnover = Sales/Assets). That means: Select: 1 Every $1.49 of profit in the firm comes from each $1.00 of sales. Each $1.00 of assets in the firm...