Question: Liquid water flows through a pipe at a mass flow rate of 100 kg/s. If the cross-sectional area of the pipe is 0.01 m2, determine

Liquid water flows through a pipe at a mass flow rate of 100 kg/s. If the cross-sectional area of the pipe is 0.01 m2, determine (a) the flow rate of momentum through the pipe.

Step by Step Solution

★★★★★

3.42 Rating (155 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

The momentum conser... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Document Format (1 attachment)

861-ME-T (7499).docx

120 KBs Word File

Students Have Also Explored These Related Mechanical Engineering Questions!

Saturated liquid water flows through a pipe at 10 MPa. Assuming thermodynamic equilibrium to exist at any given cross-section. (a) Determine the temperature (T). (b) The quality of water. A small...

Water flows through a pipe with a speed of 2.4 m/s. Find the flow rate in kg/s if the diameter of the pipe is 3.1 cm?

Air flows through a pipe at a rate of 120 L/s. The pipe consists of two sections of diameters 22 cm and 10 cm with a smooth reducing section that connects them. The pressure difference between the...

QUESTION 23 15 points Save Answer there is no rotation. A green car with mass 900 kg is travelling east at 40 m/s. Simultaneously, a yellow car with mass 1600 kg is travelling north at 30 m/s. They...

Helium steadily enters a pipe with a mass flow rate of 8 kg/s at 427C and 100 kPa and leaves the pipe at 27C. The pressure during the process is constant at 100 kPa. (a) Determine the heat transfer...

5-180 Determine the power input for a compressor that compresses helium from 150 kPa and 20C to 400 kPa and 200C. Helium enters this compressor through a 0.1-m2 pipe at a velocity of 15 m/s. 5-181...

MEM553 Problem Based Learning/ Complex Eingineering Problem GROUP ASSIGNMENT Commence Date: 4 rd Jan 2023 Dateline: 27ih Jan 2023 (Before 5 pm) Course Outcomes This assignment is established to...

Experiment: shell and tube heat exchanger counter B D C #4 4 2 3 20 5 0.1 5 0.01 7 4190 Virtual Experiment Outer Tube Radius (cm) Inner Tube Radius (cm) Tube Length (m) Mass Flow Rate of Water (kg/s)...

A schematic diagram of a water heater using solar energy is shown below. Oil is circulated through the closed circuit using a pump. Oil is heated up in the solar collector and is then passed to the...

Experiment : shell and tube heat exchanger co-courrent Virtual Experiment #4 Outer Tube Radius (cm) 2 Inner Tube Radius (cm) 1 Tube Length (m) 25 Mass Flow Rate of Water (kg/s) 0.1 Mass Flow Rate of...

For each of the following reactions, predict the MAJOR product with correctstereochemistry. (12 marks) For each of the following reactions, predict the MAJOR product with correct stereochemistry. 4....

On December 31, 2014, Pate Corporation acquired 80% of Starmont Corporations common stock for $900,000 cash. Assume that the fair values of Starmonts identifiable assets and liabilities equaled book...

The standard deviation of stock returns is used to measure the idiosyncratic risk of the stock in financeTrue or false

When a result is not significant, what can you conclude about the truth of the research hypothesis if the study had (a) a very large sample size or (b) a very small sample size?

A centrifugal pump is driven by a 50-hp synchronous motor at a speed of 1800 rev/min. The pump is to operate at 900 rev/min. Despite the speed, the load is smooth (Ks = 1.2). For a design factor of...

A mine hoist uses a 2-in 6 x 19 monitor-steel wire rope. The rope is used to haul loads of 4 tons from the shaft 480 ft deep. The drum has a diameter of 6 ft, the sheaves are of good-quality cast...

A temporary construction elevator is to be designed to carry workers and materials to a height of 90 ft. The maximum estimated load to be hoisted is 5000 lbf at a velocity not to exceed 2 ft/s. For...

Solve the diffusion problem for species A which is being consumed through 3 homogeneous reactions, two 0th order and one 1st order, and 1 heterogeneous reaction (1st order) at the boundary x = L The...

1. For each of the variables below, compute by hand (that is, with a calculator) their mean and standard deviation. Confirm your results with Minitab .(Type the numbers into separate columns in the...

I want to briefly explain these cores and examples 1. Role and function of various financial instruments for risk management 2. Explain the concept Exchange risk management and how businesses deal...