Question: A small block with mass 0.250 kg is attached to a string passing through a hole in a frictionless, horizontal surface (see Fig. 10.48). The

A small block with mass 0.250 kg is attached to a string passing through a hole in a frictionless, horizontal surface (see Fig. 10.48). The block is originally revolving in a circle with a radius of 0.800 m about the hole with a tangential speed of 4.00 m/s. The string is then pulled slowly from below, shortening the radius of the circle in which the block revolves. The breaking strength of the string is 30.0 N. What is the radius of the circle when the string breaks?

Step by Step Solution

★★★★★

3.43 Rating (156 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

IDENTIFY Angular momentum is conserved since the tension in t... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Document Format (1 attachment)

P-M-R-M (92).docx

120 KBs Word File

Students Have Also Explored These Related Mechanics Questions!

A small block with mass m rests on a frictionless horizontal tabletop a distance r from a hole in the center of the table (Fig. 5.79). A string tied to the small block passes down through the hole,...

A mass with M = 102 kg is attached to the bottom of a block-and-tackle pulley system as depicted in Figure P3.65. How much tension force is needed to keep the mass at its current position? Figure...

A closed chain A of mass m = 0.36 kg is attached to a vertical rotating shaft by means of a thread (Fig. 1.37), and rotates with a constant angular velocity ω = 35 rad/s. The thread forms an...

When a mass is attached to a vertical spring, the spring is stretched a distance d. The mass is then pulled clown from this position and released. It undergoes 45 oscillations in 3?.0 s. What was the...

In a physics laboratory class, three massless ropes are tied together at a point. A pulling force is applied along each rope: F1 = 169 N at 600, F2 = 222 N at 1009, F3 = 117 N at 190. (All angles are...

The heaviest invertebrate is the giant squid, which is estimated to have a weight of about0.15tons spread out over its length of30feet.What is its weight in newtons? N 2. [0.17/1...

Part A A light rope is wrapped several times around a large wheel with a radius of 0.365 m. The wheel rotates on frictionless bearings about a stationary horizontal axis, as shown in the figure...

Please help me with the following questions. 1. Two forces, F11 and F22, act at a point. The magnitude of F11 is 9.00 NN, and its direction is an angle 65.0 above the negative direction of x-the axis...

1. [-/2 Points] DETAILS SERCP11 8.4.P.044. A bicycle wheel has a diameter of 63.0 cm and a mass of 1.73 kg. Assume that the wheel is a n the outside radius. The bicycle is placed on a stationary...

kinetic energy is converted into potential energy. When the ball falls back to the ground, the potential energy is converted back into kinetic energy. The total amount of energy in the system remains...

Steam at 500 C and 4 MPa enters a turbine with an isentropic efficiency of 86%. The exit pressure is 100 kPa. The exiting temperature of the steam is nearest: (A) 95 C (B) 107 C (C) 118 C (D) 126 C

The table gives existing inventories of various items on the BOM given below. How many additional units of C are needed to produce 10 X's? X D (3) 1 F (4) B (2) D E E (1) E (2) Component On Hand B C...

The following string was created using which SELECT clause? Abby Rogers is an order taker for Global Fast Foods SELECT first _ name | | ' ' | | last _ name | | ' is an ' staff _ type ' for Global...

Carpenter Company has used the installment method of accounting since it began operations at the beginning of 2013. The following information pertains to its operations for 2013: Installment sales $...

write an essay dealing with the relationship between language

Draw and explain the circuit diagram along with the timing diagram for which we will get 0 WAIT pulses (T W ) using a shift register, a clock generator IC, a NAND gate and 8086 microprocessor.

a) Compute the DTFT of y[n] = n2-"u[n] (Hint: E=0 nrn %3D (1-r)2. b) Compute again the DTFT of y[n], but now use the DTFT property dX(ein) nx[n] + j Verify that the two methods give the same result.

Consider a causal LTI system described by the difference equation 1 y[n] +5y[n 1] = x[n] a) Determine the frequency response H(el") of this system. b) Find and sketch the impulse response h[n] of...

In June 2019, President Trump was frustrated that the FOMC had decided not to immediately reduce its target for the federal funds rate. On Twitter, he wrote that the Fed doesnt know what it is doing...

Write a program called CozaLozaWoza which prints the numbers 1 to 1 1 0 , 1 1 numbers per line. The program shall print "Coza" in place of the numbers which are multiples of 3 , "Loza" for multiples...

Hoping someone can help me here because my teacher never teach this lesson just handing out a lecture only. Even I search, I am still can't understand. Thank you! 1. The following are the Math final...

The General Hospital is evaluating new office equipment offered by three companies. In each case the interest rate is 15% and the useful life of the equipment is four years. Use NPW analysis to...