Question: Write the RISC I instructions in assembly language that will cause a jump to address 3200 if the Z (zero) status bit is equal to
Write the RISC I instructions in assembly language that will cause a jump to address 3200 if the Z (zero) status bit is equal to 1.
a. Using immediate mode
b. Using a relative address mode (assume that PC = 3400)
Step by Step Solution
3.34 Rating (145 Votes )
There are 3 Steps involved in it
To perform a conditional jump to address 3200 based on the Z zero status bit you can use the RISC I ... View full answer
Get step-by-step solutions from verified subject matter experts
