Question: An incompressible CFD code is used to simulate the flow of air through a two-dimensional rectangular channel (Fig. P1513C). The computational domain consists of four

An incompressible CFD code is used to simulate the flow of air through a two-dimensional rectangular channel (Fig. P15–13C). The computational domain consists of four blocks, as indicated. Flow enters block 4 from the upper right and exits block 1 to the left as shown. Inlet velocity V is known and outlet pressure P_out is also known. Label the boundary conditions that should be applied to every edge of every block of this computational domain.

FIGURE P15–13C

Out Block 1 -Pout Block 2 In Block 3 Block 4

Step by Step Solution

★★★★★

3.36 Rating (171 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

The following boundary conditions should be applied to every edge of every block of the computationa... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Fluid Mechanics Questions!

Consider Prob. 1513C again, except let the boundary condition on the common edge between blocks 1 and 2 be a fan with a specified pressure rise from right to left across the fan. Suppose an...

An incompressible CFD code is used to simulate the flow of water through a two-dimensional rectangular channel in which there is a circular cylinder (Fig. P1518). A time-averaged turbulent flow...

An incompressible CFD code is used to simulate the flow of gasoline through a two-dimensional rectangular channel in which there is a large circular settling chamber (Fig. P1519). Flow enters from...

Sketch a structured multiblock grid with four sided elementary blocks for the computational domain of Prob. 1525. Each block is to have four-sided structured cells, but you do not have to sketch the...

In Prob. 1519 we take advantage of topbottom symmetry when constructing our computational domain and grid. Why cant we also take advantage of the rightleft symmetry in this exercise? Repeat the...

Anita runs a CFD code using the computational domain and grid developed in Probs. 1522 and 1523. Unfortunately, the CFD code has a difficult time converging and Anita realizes that there is reverse...

Sketch a coarse structured multiblock grid with four sided elementary blocks and four-sided cells for the computational domain of Prob. 1522. Data from Problem 15-22 A new heat exchanger is being...

Fong Corp. reported various transactions in 20X2: a. Equipment with an original cost of $32,500 and accumulated depreciation of $26,000 was deemed unusable and was sold for $250 scrap value. b. A new...

Assigned overhead is calcukated: a)the PDOR rate times eatinated activity b)the PDOR rate times actual activity c)accountanta adding all receiots at year end d)none if the above

An overnight shipping firm operates major sorting facilities (hubs) in six cities. To compare the performance of the hubs, it tracked the shipping time (in hours) required to process 20 randomly...

Penn Inc.s assets have the carrying values and estimated fair values as follows: Required a. Prepare a schedule to calculate the net estimated amount available for general unsecured creditors. b....

What is the partial pressure of water on a day when the temperature is 25oC and the relative humidity is 35%?

Develop the PCS security program charter for the corporate net work and satellite offices

What would be the facilitators and obstacles to standardization?

The flow rate of water in a 3-m-wide horizontal open channel is being measured with a 0.4-m-high sharp-crested rectangular weir of equal width. If the water depth upstream is 0.9 m, the flow rate of...

Water is released from a 0.8-m-deep reservoir into a 4-m-wide open channel through a sluice gate with a 0.1-m-high opening at the channel bottom. The flow depth after all turbulence subsides is 0.5...

please please type the answer instead of posting an image How would your analysis in questions 2 and 3 and recommendation in question 4 change if the new tax law is implemented? Please note that,...

A company uses the allowance method to account for bad debts. What is the effect on each of the following accounts of the collection of an account previously written off? Option C Option B Option A...

Compute the Manufacturing Overhead Amount Applied to Jobs Given the Following; Direct Materials Used=$100,000, Direct Labor=$200,000, In-Direct Labor=$140,000, Factory Rent Costs=$160,000. The...