Question: Consider laminar flow in a circular pipe. Is the wall shear stress w higher near the inlet of the pipe or near the exit?

Consider laminar flow in a circular pipe. Is the wall shear stress τ_w higher near the inlet of the pipe or near the exit? Why? What would your response be if the flow were turbulent?

Step by Step Solution

★★★★★

3.40 Rating (159 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

We are to compare the wall shear stress at the inlet and outlet of a pipe An... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Fundamentals Thermal Fluid Questions!

Please help Accounting question Snavely, Inc., manufactures and sells two products: Product E1 and Product A7. Data concerning the expected production of each product and the expected total direct...

Consider fully developed laminar flow in a circular pipe. If the diameter of the pipe is reduced by half while the flow rate and the pipe length are held constant, the head loss will (a) Double, (b)...

Consider fully developed laminar flow in a circular pipe. If the viscosity of the fluid is reduced by half by heating while the flow rate is held constant, how does the head loss change?

A glass manometer with oil as the working fluid is connected to an air duct as shown in Fig. P12??11. Will the oil levels in the manometer be as in Fig. P12??11Ca or b? Explain. What would your...

1. Discuss Reynolds analogy and its limitations. 2. A4-m x 4-m flat plate maintained at a constant temperature of 80C is subjected to parallel flow of air at 1 atm, 20C, and 10 m/s. The total drag...

Consider laminar flow in a circular tube. Will the friction factor be higher near the inlet of the tube or near the exit? Why? What would your response be if the flow were turbulent?

Q 4 : ( i ) The water needs of a small farm are to be met by pumping water from a well that can supply water continuously to a large reservoir on a hill at a rate of 0 . 0 0 4 m 3 s using 5 cm...

Laminar and Turbulent Flow 8 - 1 C Consider the flow of air and water in pipes of the same diameter, at the same temperature, and at the same mean velocity. Which flow is more likely to be turbulent?...

Problem 2B.15. Shell momentum balances and pressure distribution for flow through a circular tube. In example 2.3, only the z momentum balance was derived. Answer the following questions. a. Derive...

ATTEMPT ALL QUESTIONS. BE SURE TO ANSWER A body with mass m = 1 2 kg is attached to the end of a spring that is stretched 2 m by a force of 100 N. Furthermore, there is also attached a dashpot4 that...

5-180 Determine the power input for a compressor that compresses helium from 150 kPa and 20C to 400 kPa and 200C. Helium enters this compressor through a 0.1-m2 pipe at a velocity of 15 m/s. 5-181...

Describe two ratios that measure current liquidity, and compare the information they provide. Which measure is more likely to produce the lowest result for most companies? Why is this the case?

A corporation has 200,000 shares of $10par value common stock outstanding. The following selected transactions related to the company's stock took place during the current year: Apr. 15 Declared a...

Which of the following ltems would definitely NOT be allowed as a tax expense under Tax Accounting principles? A . Replocement of loose tools used in business B . Provision for doubeful debes C . A...

5. Determination of requirements for audit trail dataDifferent customers and stakeholders have different requirements for record retention used in postproject audits. The project team needs to...

The flow rate of water in a 6-m-wide rectangular channel is to be measured using a 1.1-m-high sharp-crested rectangular weir that spans across the channel. If the head above the weir crest is 0.60 m...

Consider water flow through a V-shaped channel. Determine the angle the channel makes from the horizontal for which the flow is most efficient. FIGURE P13134 y

Brooks Company leases a machine from TCS Company on 1 / 1 / 2 3 . Given: wet ered 5 out of g question Asset FMV $ 1 0 0 , 0 0 0 Asset Book Value $ 8 5 , 0 0 0 January 1 payments $ 2 0 , 7 1 1...

Upton Computers makes bulk purchases of small computers, stocks them in conveniently located warehouses, ships them to its chain of retail stores, and has a staff to advise customers and help them...

Overnight Publishing Company (OPC) has $3.2 million in excess cash. The firm plans to use this cash either to retire all of its outstanding debt or to repurchase equity. The firms debt is held by one...