Question: A 600-lb force acts on the vertical plate, which in turn is connected to the horizontal truss by five 3/16 -in.-diameter rivets (Figure P5.21). (a)

A 600-lb force acts on the vertical plate, which in turn is connected to the horizontal truss by five 3/16 -in.-diameter rivets (Figure P5.21).

(a) If the rivets share the load equally, determine the shear stress in them.

(b) In a worst-case scenario, four of the rivets have corroded, and the load is carried by only one rivet. What is the shear stress in this case?


Figure P5.21

600 lb Rivet detail

600 lb Rivet detail

Step by Step Solution

★★★★★

3.32 Rating (173 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock

a Since the load is shared equally by five rivets the force ac... View full answer

blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Introduction Mechanical Engineering Questions!

Q:

The 50-lb plate ABCD is attached at A and D to collars that can slide on the vertical rod. Knowing that the coefficient of static friction is 0.40 between both collars and the rod, determine whether...

Q:

A horizontal force acts on the end of the link as shown. Determine the angles 1 and 2 for equilibrium of the two links. Each link is uniform and has a mass m.

Q:

The handle of the sector press is fixed to gear G, which in turn is in mesh with the sector gear C. Note that AB is pinned at its ends to gear C and the underside of the table EF, which is allowed to...

Q:

The force F has a magnitude of 6 0 0 l b and acts along the line A M where M is the midpoint of the vertical side O B of the parallelepiped. Express F as its magnitude times the appropriate unit...

Q:

Determine the design angle ? (0? ? ? ? 90?) between strut AB and AC so that the 400-lb horizontal force has a component of 600-lb which acts up to the left, in the same direction as from B towards A....

Q:

(Multiple Choice) (1) An object is observed to be moving at constant velocity in an inertial reference frame. It follows that (a) No forces act on the object. (b) A constant force acts on the object...

Q:

A long thin rod is pinned so that it can rotate around a point onefourth of the length of the rod from its right end; as shown in the gure loelow. A force F acls downward in the gure at the right end...

Q:

E-Physics Tutorial Book Note: I have attached below the lesson for the 3 activities. Thank you so much for your time and effort. Activity 1. Directions: Use the right-hand rule to determine the...

Q:

15 Turning on a pivot 1 Which statement best describes a lever? Tick () the correct box. It changes the size of a force. It changes the direction of a force. 0 It changes the size or direction of a...

Q:

Subject: Science, Physics, not General Physics. Topic: Turning on a pivot. Would you mind helping me answer all these questions on a pink box numbers 1-7 (pages 191-192) and all the end of chapter...

Q:

The SI unit of force, the kilogram-meter per second squared (kg-m/s 2 ) is called the Newton (N). Find the dimensions and the SI units of the constant G in Newtons law of gravitation F = Gm 1 m 2 /r...

Q:

In a particular dynamic memory chip, C,= 25 fF, the bit-line capacitance per cell is 1 fF, and bit-line control cir- cuitry involves 12 fF. For a 1-Mbit-square array, what bit- line signals result...

Q:

Hammer Company proposes to invest 6 million in a new type of hammer making equipment. The fixed costs are 1 million per year. The equipment will last 5 years. The manufacturing cost per hammer is $ 1...

Q:

In what ways does TerraCycle alter the traditional value chain? In what ways does this encourage consumers to take on new roles or behaviors? Is the TerraCycle model sustainable? Why or why not? What...

Q:

Explain the working of Cochran boiler and fusible plug with neat sketches.

Q:

Explain the construction and working of a pressure gauge with a neat sketch.

Q:

State the advantages of high-pressure boilers. Explain the construction and working of Babcock and Wilcox boiler with a neat sketch.

Q:

Please help me actually fill out the forms, I am lost on several parts of this question. 1A. Richard McCarthy (born 2/14/1967; Social Security number 100-10-9090) and Christine McCarthy (born...

Q:

A company is forecasted to generate free cash flows of $40 million next year ( t=1 ) and $70 million the year after (t=2). After that, cash flows are projected to grow at a 2.5% annual rate in...

Q:

BAD Company's stock price is $30, and the firm has 4 million shares outstanding. You believe you can increase the company's value if you buy it and replace the management. Assume that BAD has a...