A single phase full wave bridge rectifier using phase controlled thyristors with a large L dc converts 60 Hz, 120 V rms to dc for a dc side load resistance of 10 For the firing delay angle 60, determine the dc side voltage and the power absorbed by the load, ignoring the cable inductances and ripples

Question: A single-phase full-wave bridge rectifier using phase-controlled thyristors with a large L dc converts 60 Hz, 120 V rms to dc for a dc side

A single-phase full-wave bridge rectifier using phase-controlled thyristors with a large L_dc converts 60 Hz, 120 V rms to dc for a dc side load resistance of 10 Ω. For the firing delay angle α = 60°, determine the dc side voltage and the power absorbed by the load, ignoring the cable inductances and ripples.

Step by Step Solution

★★★★★

3.37 Rating (150 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

We use Equation 142 to obtain V dc 09 120 cos 60 54 V Then I dc 5... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Introduction To Electrical Power Questions!

The rectifier of Example 14.2 with the ac side cable inductance of 3 mH and the dc side cable resistance of 1.0 is charging a battery at a 10-A charge rate instead of powering the 10- resistance....

The rectifier of Example 14.2 with the ac side cable inductance of 2 mH and the dc side cable resistance of 0.5 is charging a battery at 5.4-A charge rate instead of powering the 10- resistance....

A single-phase full-bridge bridge rectifier using phase-controlled thyristors with a large Ldc converts 50-Hz, 240-V rms to dc for a dc side load resistance of 12 . For the firing delay angle = 30,...

1. Define organization Behavior. 2. List the types of personality. 3. Difference between emotional intelligence and emotional Labour. 4. What do you understand by group dynamics? 5. Define...

A power electronics engineer is assigned to design a rectification stage for an AC - DC converter, prioritizing high power efficiency and low harmonic distortion to support sensitive equipment. Which...

M4 AssM4 Assignment: Solve the following problems: 1. A single-phase full-wave bridge rectifier has a resistive load of 18 and an ac source of 120-V rms. Determine the average, peak, and rms currents...

An uncontrolled single - phase full - wave bridge rectifier is connected to a pure resistive load with R = 5 The peak value of the source voltage is 1 7 0 V , and its frequency is 6 0 Hz . Assuming...

M4 Assignment: Solve the following problems: 1. A single-phase full-wave bridge rectifier has a resistive load of 18 and an ac source of 120-V rms. Determine the average, peak, and rms currents in...

A controlled single - phase full - wave bridge rectifier has an RL load with R = 2 5 and L = 5 0 mH . The source is 2 4 0 V rms at 6 0 Hz . Determine the average load current for ( a ) = 1 5 and ( b...

M4 Assignment: Solve the following problems: 1. A single-phase full-wave bridge rectifier has a resistive load of 18 and an ac source of 120-V rms. Determine the average, peak, and rms currents in...

The exchange of deuterium between acid and water is an important type of equilibrium, and we can examine it using spectroscopic data on the molecules. Calculate the equilibrium constant at (a) 298 K...

A gear reduction unit uses the countershaft shown in the figure. Gear A receives power from another gear with the transmitted force FA applied at the 20_ pressure angle as shown. The power is...

If a company intends to refinance a liability that is due within one year and has the ability to do so , that liability, that liability should not be classified as a current liability. Group...

15. How do changes in the balances of deferred income taxes affect the amoimt of cash paid for income taxes?

Estimate the friction angle of the soil C in Problem 2.7 (see Figure P2.7) at 80% relative density and void ratio of 0.61 using the empirical correlations given by a. Eq. (2.87) b. Eq. (2.88) Figure...

A Shelby tube has outside diameter of 76.2 mm and wall thickness of 1.651 mm. What is the area ratio of the tube?

A thin-walled sampling tube must be fabricated to obtain good-quality undisturbed clay samples of 75 mm diameter. What is the maximum possible wall thickness?

What effect would each of the following events likely have on the level of nominal interest rates? Households dramatically increase their savings rate. This action will the supply of money;...

2. Budgets incorporate managements goals and A. are a strategic long range plan B. are both a short range and long range profit plan C. includes only financial aspects of an operation as those are...

ABC Co uses the percentage of sales method to record Bad debt expense. Calculate the Bad debt expense for 2022 if Credit Sales were $5,000,000 and ABC uses a bad debt estimate of 5%.