A single phase full bridge bridge rectifier using phase controlled thyristors with a large Ldc converts 50 Hz, 240 V rms to dc for a dc side load resistance of 12 For the firing delay angle 30, determine the dc side voltage and the power absorbed by the load, ignoring the cable inductances and ripples

Question: A single-phase full-bridge bridge rectifier using phase-controlled thyristors with a large Ldc converts 50-Hz, 240-V rms to dc for a dc side load resistance of

A single-phase full-bridge bridge rectifier using phase-controlled thyristors with a large Ldc converts 50-Hz, 240-V rms to dc for a dc side load resistance of 12 Ω. For the firing delay angle α = 30°, determine the dc side voltage and the power absorbed by the load, ignoring the cable inductances and ripples.

Step by Step Solution

★★★★★

3.34 Rating (154 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

To determine the DC side voltage and the power absorbed by the load in a singlephase fullbridge bridge rectifier using phasecontrolled thyristors with ... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Introduction To Electrical Power Questions!

The rectifier of Example 14.2 with the ac side cable inductance of 3 mH and the dc side cable resistance of 1.0 is charging a battery at a 10-A charge rate instead of powering the 10- resistance....

The rectifier of Example 14.2 with the ac side cable inductance of 2 mH and the dc side cable resistance of 0.5 is charging a battery at 5.4-A charge rate instead of powering the 10- resistance....

A single-phase full-wave bridge rectifier using phase-controlled thyristors with a large L dc converts 60 Hz, 120 V rms to dc for a dc side load resistance of 10 . For the firing delay angle = 60,...

A power electronics engineer is assigned to design a rectification stage for an AC - DC converter, prioritizing high power efficiency and low harmonic distortion to support sensitive equipment. Which...

1.What is organisational communication? 2.How important is communication to mangers? 3. List and describe micro and macro barriers of effective communication 4.Discuss they types of formal...

M4 AssM4 Assignment: Solve the following problems: 1. A single-phase full-wave bridge rectifier has a resistive load of 18 and an ac source of 120-V rms. Determine the average, peak, and rms currents...

Question 1: A single-phase, full-bridge diode rectifier fed from a 230 V, 50 Hz sinusoidal source supplies a series combination of finite resistance, R, and a very large inductance, L. The two most...

Discuss they types of formal organisation of communication and explain the general purpose of each type. 5.Explain the terms operational management as well as major managerial activities involved in...

Input voltage and thyristor trigger signals of the following single-phase semi-controlled bridge rectifier circuit given below. a) Draw the waveforms of the voltage on the load and on a thyristor. b)...

In the single-phase half-controlled bridge rectifier shown below, the source voltage v, is 240 V rms. The load resistance is R = 10 Q. (a) If the load inductance L is very large (load current...

Carter Containers sold marketable equity securities, land, and common stock for $28.0 million, $18.0 million, and $45.0 million, respectively. Carter also purchased treasury stock, equipment, and a...

Put a uniform meter scale horizontally on your extended index fingers with the left one at 0.00 cm and the right one at 90.00 cm. When you attempt to move both the fingers slowly towards the center,...

Your parents set up a trust for you that younwill not have access to until your 3 0 th birthday

14. What was the most significant change in accounting for income tax carryforwards made by FASB ^ Statement No. 109?

The specimens obtained from a clay layer at a site gave the following shear strength parameters from a consolidated-drained triaxial test: c' = 10 kN/m 2 and ' = 26. A consolidated undrained triaxial...

The data from a series of consolidated-undrained triaxial tests are summarized below. Draw the three Mohr circles, plot the failure envelope in terms of effective stresses, and find c' and f'....

Steel plates with mass of 1500 g each were stacked on top of a 75 mm diameter and 150 mm high clay specimen, as shown in Figure P2.22. If the undrained shear strength of the specimen is 45.0 kN/m 2 ,...

Described the events leading up to the war in lemon tree

At $88 , a firm can sell 4,810 stereo earphones (3.5 mm for android). At this price, elasticity is estimated at 2.2. What is the change in total revenue (+ or -) if the firm drops price by 10%? Round...

Use the information provided below to answer the following questions: $9,600 Sales ($50 per unit) Cost of goods sold (all variable costs) Fixed costs 5,760 2,720 (a) How many units would the company...