Question: Why do the activity coefficients of ions in solution differ from 1? Why are they less than 1 in dilute solutions?

Why do the activity coefficients of ions in solution differ from 1? Why are they less than 1 in dilute solutions?

Step by Step Solution

★★★★★

3.60 Rating (161 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock

yes activity coefficient can be ... View full answer

blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Physical Chemistry Questions!

Q:

Discuss why the standard entropies of ions in solution may be positive, negative, or zero.

Q:

The mean activity coefficients of KCI in three dilute aqueous solutions at 25C are 0.927 (at 5.0 mmol kg-I), 0.902 (at 10.0 mmol kg-I), and 0.816 (at 50.0 mmol kg"). Estimate the value of B in the...

Q:

Why were IBFs created? How do they differ from Edge Act and Agreement corporations?

Q:

Why is it impossible to measure activity coefficients for individual ions? What can we can measure instead? Which theory enable us to calculate activity coefficients of ions in diluted solutions? In...

Q:

Hi I could use some help with this chemistry question please thanks alot. f. Calculate the mass of solid Cr(OH)3 that would be collected from the entire class. (1 pt.) g. Assuming the solid from the...

Q:

Determine the amount of silver in the sample solution in ppm. [1 marks] (d) (i) A concentration cell having two electrodes of a metal x, one dipping into an 0.125M solution of one of its salt and the...

Q:

Calculation : (1) Total solubility of AgAc in the solution (M): (Hint: use the concentration and the volume of KSCN in the titration to find the total concentration of AgAc)...

Q:

Ring method (manual method) The main instrument is an electronic balance by Lauda. It can be used for surface tension measurements following du Noy (ring), Wilhelmy (plate), or Lenard (wire), as well...

Q:

Introduction: or Solutions that contain a maximum amount of a certain solute at a given temperature are said to be saturated. The concentration of the solute in question is equal is called the...

Q:

Use the equation of the calibration line to calculate the concentration of the metal in the soil solution. Show labeled calculation. -- I need help to calculate the concentration Below is the data I...

Q:

1. Referring to Fig. 4-1, reverse the polarity of battery En and the current direction through resistor Rg. (a) Write Kirchhoff's current equation at junction p. (6) Write Kirehhoff's voltage...

Q:

When should you write a memo? When should you write a letter?

Q:

Investors who do not consider risk ( that is , those investors who only consider the expected return ) in their decisions are

Q:

If you were Latoya and Beth drafted a policy and department members agreed with it, what would you do? (a) Would you appeal the decision to the dean? (b) Again, would your answer change if you had...

Q:

Why is the standard state of fugacity, f , equal to the standard state of pressure, P?

Q:

A compressed cylinder of gas contains 2.74 10 3 g of N 2 gas at a pressure of 3.75 10 7 Pa and a temperature of 18.7C. What volume of gas has been released into the atmosphere if the final pressure...

Q:

Explain the significance of the Boyle temperature.

Q:

a. (4 points) You purchased a zero coupon bond one year ago for \$249.95. The market interest rate is now 9 percent (please keep in mind that this number is compounded semi-annually by convention)....

Q:

4. Case study A tech industries Inc. has initial resources equal to $150 million. Because management estimates that optimal operation requires an investment of $200 million, the firm must raise an...

Q:

The probability distribution of returns of Stutson Gheegi Manufacturing is presented below. what is the standard deviation of returns of Stutson Gheegi? (recurring content question) 24.60% 124,2%...