Question: A production process realizes shafts whose diameter is normally distributed with = 34.08mm o = 0.05mm. If the tolerances are 34.00 0.15 mm,


A production process realizes shafts whose diameter is normally distributed with

µ = 34.08mm o = 0.05mm.

If the tolerances are 34.00 ± 0.15 mm, what is the probability of producing a shaft falling out of the tolerances?

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Quality Management Questions!

Q:

2. An auto manufacture wants shafts of diameter 3+-0.005 inches. The supplier's production process produces shafts with a mean of 3.002 inches with a standard deviation of 0.0018. Compute Cp and Cpk...

Q:

Ten samples of size =8 have been collected from a production process manufacturing shafts for fuel pumps. The shaft diameter is critical and it has been measured for each shaft. The process is in...

Q:

Q#1) HCH Inc. has decided to use ap-Chart with 2-sigma control limits to monitor the proportion of defective steel handles produced by their production process. The quality control manager randomly...

Q:

1. You are a purchaser and a quality management expert. A manufacturer of different automobile products received an order to supply 2,500 shafts, 4 inches long and 2 inch- diameter which are driving...

Q:

1. You are a purchaser and a quality management expert. A manufacturer of different automobile products received an order to supply 2,500 shafts, 4 inches long and 2 inch- diameter which are driving...

Q:

please show all work 1. You are a purchaser and a quality management expert. A manufacturer of different automobile products received an order to supply 2,500 shafts, 4 inches long and 2 inchdiameter...

Q:

SHOW WORK 1. You are a purchaser and a quality management expert. A manufacturer of different automobile products received an order to supply 5000 shafts, 5 inches long and 3 inch- diameter which are...

Q:

SHOW ALL WORK AND LABEL 2. We learnt from the power point slides, the importance of process capability. Six-sigma concept and application are closely related with process capability, which is another...

Q:

SHOW ALL WORK PLEASE 1. You are a purchaser and a quality management expert. A manufacturer of different automobile products received an order to supply 5000 shafts, 5 inches long and 3 inch-...

Q:

SO 349 Milestone Two Guidelines and Rubric In Module Three, you will submit a procurement regulations and source selection document with more of your analysis for your selected case study. First,...

Q:

Suppose that you've been asked by the San Diego Padres baseball team to evaluate the economic impact of their new stadium by ana- lyzing the team's attendance per game in the last year at their old...

Q:

How would you respond to the criticism that EOQ models tend to provide misleading results because values of D, S, and H are, at best, educated guesses?

Q:

What is the difference between " My Private Documents" and "Shared Documents" for clients in the Vault?

Q:

Consider a general closed-loop unity feedback control system shown in Figure 5.34, where \(K\) is the controller gain and \(G(s)\) is the plant Transfer Function model. Using simple rules, sketch the...