Question: ? ? 12.9 Determine the maximum load that can be allowed on the 450 mm diameter pile shown in Figure P12.9, with a factor of

12.9 Determine the maximum load that can be allowed on the 450

(12.20). Q, a N? Cu Ap = 9c, Ap

Table 12.11. Variation of a (Interpolated Values Based on Terzaghi et al., 1996) ?? -Pa a< 0.1 1.00 0.2 0.92 0.3 0.82 0.4 0.

1.4 0.40 1.6 0.38 1.8 0.36 2.0 0.35 2.4 0.34 2.8 0.34 ?

12.9 Determine the maximum load that can be allowed on the 450 mm diameter pile shown in Figure P12.9, with a factor of safety of 3. Use the a method and Table 12.11 for determining the skin friction and Eq. (12.20) for determining the point load.

Step by Step Solution

★★★★★

3.46 Rating (146 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

Given data Pilo dia 1 380 mm x s not given Comsidering ... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Accounting Questions!

Determine the maximum load that can be allowed on the 450 mm diameter pile shown in Figure P12.9, with a factor of safety of 3. Use the a method and Table 12.11 for determining the skin friction and...

Determine the maximum load that can be allowed on a 450 mm diameter driven pile shown in Figure P12.6, allowing a factor of safety of 3. Use K = 1.5 K o and ' = 0.65' in computing the shaft load. Use...

The top 5 m in a site consists of a clay with c u = 80 kN/m 2 . This is underlain by a thick clay deposit with c u = 150 kN/m 2 . A 1.0 m diameter and 15 m long straight drilled shaft is constructed...

A constant-volume tank has a temperature of 800 K and a constant-pressure device has a temperature of 290 K. Both the tank and device are filled with 20 kg of air. A heat engine placed between the...

The drive shaft for a truck (outer diameter 60 mm and inner diameter 40 mm) is running at 2500 rpm (see figure). (a) If the shaft transmits 150 kW, what is the maximum shear stress in the shaft? (b)...

The boom has length L, weight Wb, and mass center at G. If the maximum moment that can be developed by the motor at A is M, determine the maximum load W, having a mass center at G', that can be...

A sandstone bed with RQD = 70% and = 26.0 kN/m 3 lies beneath 1.5 m of overburden soil. A 2.0 m 2.0 m square foundation is to be placed on top of the sandstone rock (i.e., at a 1.5 depth below the...

Determine the maximum power that can be delivered to the load RL in the network shown. 1KC 1KC

A constant-volume tank contains 20 kg of nitrogen at 1000 K, and a constant-pressure device contains 10 kg of argon at 300 K. A heat engine placed between the tank and device extracts heat from the...

Determine the bit rate and the resolution in the sampling of a seismic signal with dynamic range of 1 volt if the sampling rate is Fs = 20 samples/s and we use an 8-bit A/D converter? What is the...

Zee Corporation had 3,600 units one-fourth completed at the beginning of the period, 12,000 units were completed and transferred during the period, 2,000 units were one-fifth completed at the end of...

A worker views leisure and income as "goods" and has an opportunity to work at an hourly wage of $16 per hour. a. The worker's opportunity set in a given 24-hour period is illustrated below.What are...

Question 26 [2 points} Using expansionary policies to combat a recession would 0 increase a budget deficit. 0 increase a budget surplus. 0 decrease discretionary spending. 0 increase federal revenue....

To analyze a complex negotiation (work, personal, or historical) To apply negotiation course concepts in your analysis. These objectives, while straightforward, are critical to your learning....

What Would You Do? Michael Michael is a student in your fifth-grade class. His father passed away in an automobile accident last year. Before his father's death Michael always did well in school and...

Exercise 8-23 (Algo) Preparing a balance sheet LO P1, P3, P4 Selected accounts from Gregor Company's adjusted trial balance for the year ended December 31 follow. Prepare a classified balance sheet....

B B 0700195% 8:16 s1.lite.msu.edu/res/ms 6 Info Transaction 8 On March 1, fixtures and equipment were purchased for $4,000 with a downpayment of $1,500 and a $2,500 note, payable in one year....

Critical reading SAT scores are distributed as N(500, 100). a. Find the SAT score at the 75th percentile. b. Find the SAT score at the 25th percentile. c. Find the interquartile range for SAT scores....

The thickness of the active zone in an expansive clay is 3 m. The liquid limit of the clay is 50. If the natural moisture content is 20%, what would be the free swell at the ground level?

The specimens obtained from a clay layer at a site gave the following shear strength parameters from a consolidated-drained triaxial test: c' = 10 kN/m 2 and ' = 26. A consolidated undrained triaxial...

Redo Problem 3.5 using Eq. (3.14). Problem 3.5 Following is the variation of the field standard penetration number (N 60 ) in a sand deposit: Depth (m) .............. N 60 1.5...

Consumer Digest recently reported that car batteries X, Y, and Z have average service lives of three, four, and six years, respectively. Grace found that the best retail prices for these batteries in...

Machine A costs $40,000 and is forecast to generate an annual profit of $15,000 for four years. Machine B, priced at $60,000, will produce the same annual profits for eight years. The trade-in value...

Determine the IRR on the ginseng crop in Problem 3 of Exercise 16.2. In Problem 3 The pro forma projections for growing a 20-hectare ginseng crop require the expenditure of $150,000 in the summer...