Question: 1. A single sampling plan is used. 15 samples are taken for the test. It is known that 8% of the samples from the

1. A single sampling plan is used. 15 samples are taken for the test. It is known that 8% of the samples from the

1. A single sampling plan is used. 15 samples are taken for the test. It is known that 8% of the samples from the production lime are found to be defective. Calculate the probability of acceptance and the producer's risk assuming the distribution is based on binomial distribution. i) The acceptance number is 1. AQL = 0.08, n=15, c = 1 ii) the acceptance number is 2. AQL=0.08, n=15, c = 2 iii) Which acceptance number (1 or 2) in should be selected in order to minimise the probability that a good lot will be rejected by the sampling plan? iv) Suppose the lot size is 10,000 and the acceptance number is 2, what is the Average Outgoing Quality (AOQ)?

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

To calculate the probability of acceptance and the producers risk we can use the binomial distributi... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Statistics Questions!

USX is considering adding an additional furnace that will operate for ten years. Last year the company commissioned a feasibility study that cost $1 million. The study came up with the following...

There are four activities along the critical path for a project. The expected values and variances of the completion times of the activities are listed here. Determine the expected value and variance...

Find the h-parameters of the circuit in Fig. 13-25 from its Z-parameters and compare with the results of Problem 13.16. Data from problem 13.16 Find the h-parameters of the circuit in Fig. 13-25. V 1...

Following are the communication practices to facilitate collaboration among team members and stakeholders for green house building project development

1.1. A food processing plant receives a shipment with 25% defectives. They use a single sampling plan with an acceptance number of 2 and a sample size of 8. What is the probability of accepting the...

UNIT 5 QZ, Q-20 UNIT 5 / UNIT 8 QUESTIONS KEEP ANSWERS SEPARATE BY UNITS UNIT II STUDY GUIDE Consumer Mathematics Reading Assignment See information below. Key Terms 1. Add-on interest method 2....

3 Rubric & Answers - Semrau Question 1 Is the study population identified and described? Are eligibility criteria specified? Are the sample selection procedures clearly delineated? Study Population...

Given that a sample of size 60 and a population standard deviation of 1.3, what would be the margin of error at a 95% level of confidence? (Points : 1) 0.01 3.29 0.33 0.4452 Question 4.4. Which of...

After reading and studying the material for week13, summarize the key terms and concepts discussed. T Test for Independent Samples - Chapter 10 Independent-Measures Designs The independent-measures...

Problem 10-25 (Algo) Resistors for electronic circuits are manufactured on a high-speed automated machine. The machine is set up to produce a large run of resistors of 1,000 ohms each. Use Exhibit...

ABL shares are currently trading at a price of $30, while HHT shares are trading at a price of $48.96. The risk-free rate is 1.29% per year. Using the information above, perform each of the following...

Construct a half adder using NAND gates.

5. Write an assignment statement that assigns the word July to a String variable named strMonth. Also write assignment statements that assign the numbers 4 and 20 to Integer variables named...

Banked Cone I A curve with a 120-m radius on a level road is banked at the correct angle for a speed of 20 m/s. If an automobile rounds this curve at 30 m/s. what is the minimum coefficient of static...

In another version of the "Giant Swing" (see Exercise 5.52), the seat is connected to two cables as shown in Fig. 5.58, one of which is horizontal. The seat swings in a h0ri2ontal circle at a rate of...

During 2010, Robin Wright Tool Company purchased a building site or its proposed research and development laboratory at a cost of $60,000. Construction of the building was started in 2010. The...

What potential difference is needed to stop an electron having an initial speed of 4.20 x 105 m/s?

This question should be answered only after Research and Application 520 are completed. Required: 1. Referring to the data for Blue Nile in Research and Application 5-20 and the data on net sales...

What roles do strategic leadership and corporate governance play in strategic management? A . Strategic leadership provides vision and direction for organizational growth B . Corporate governance...

(a) Let A = {n2|n Z+}. Find a one-to-one correspondence between Z+ and A. (b) Find a one-to-one correspondence between Z+ and {2, 6, 10, 14, ...}.

Determine the number of integer solutions to x1 + x2 + x3 + x4 = 19 where - 5

Apply Dijkstra's algorithm to the weighted directed multigraph shown in Fig. 13.33, and find the shortest distance from vertex a to the other seven vertices in the graph. 15 4 14 Figure 13.33

a. Using the information provided in Problem 2 of Chapter 9, determine the proportion of residual variation that is explained by the addition of X2 to a model already containing X1; that is, compute...

Refer to the following ANOVA tables and to SAS output given here (from data in Problem 8 of Chapter 8) to answer the following questions dealing with factors related to soil erosion. a. Using the...

Refer to Problem 7 of Chapter 9 to answer the following questions about the relationship of homicide rate (Y) to city population size (X1), percentage of families with yearly incomes less than $5,000...