1. An 8085A microprocessor based system has the following memory chips and I/O devices. The relevant...
Fantastic news! We've Found the answer you've been seeking!
Question:
Transcribed Image Text:
1. An 8085A microprocessor based system has the following memory chips and I/O devices. The relevant control pins of each chip are also indicated: RAM 6264(4Kx8): OE, WE, CS EPROM 2764(8Kx8): OE, CS 8-LEDs and 8-Toggle switches. 2 chips 1 chip Develop the system bus of the system including the RESET circuit using 74LS373 latch. Design an interfacing circuit to interface ROM, RAM and I/O devices. I/O devices are interfaced using standard I/O. Give addresses of memory and I/O devices. Use 74LS138 (3Lx8L decoder having two active LOW and one active HIGH enable inputs) for interfacing. Use Fold Back Addresses to simplify the interfacing circuit. [10] 1. An 8085A microprocessor based system has the following memory chips and I/O devices. The relevant control pins of each chip are also indicated: RAM 6264(4Kx8): OE, WE, CS EPROM 2764(8Kx8): OE, CS 8-LEDs and 8-Toggle switches. 2 chips 1 chip Develop the system bus of the system including the RESET circuit using 74LS373 latch. Design an interfacing circuit to interface ROM, RAM and I/O devices. I/O devices are interfaced using standard I/O. Give addresses of memory and I/O devices. Use 74LS138 (3Lx8L decoder having two active LOW and one active HIGH enable inputs) for interfacing. Use Fold Back Addresses to simplify the interfacing circuit. [10]
Expert Answer:
Answer rating: 100% (QA)
javascript code for solving inverse interpolation Conside... View the full answer
Related Book For
Posted Date:
Students also viewed these organizational behavior questions
-
An analog system has the following input-output relation, and zero otherwise. The input is x(t) and y(t) is the output. (a) Is this system LTI? If so, can you determine without any computation the...
-
A slow FH/MFSK system has the following parameters: Number of bits per MFSK symbol = 4 Number of MFSK symbols per hop = 5. Calculate the processing gain of the system.
-
A lean system has the following characteristics: Demand rate = 20 parts per hour; safety stock required = 5 percent; number of containers used = 14; lead time to replenish an order = 6 hours. a)...
-
The system shown consists of 3 cables. For example; cable C12 joins points 1 and 2. The coordinates of point 1 are (6.4, 0, 0) m, those of point 2 are (0, 9.5, -6.1) m, and those of point 3 are (0,...
-
Describe some ramifications of the bullwhip effect.
-
Two parallel-plate capacitors have the same plate area. Capacitor 1 has a plate separation twice that of capacitor 2 , and the potential difference you impose across the plates of capacitor 1 is...
-
At constant temperature and pressure, the free energy for a chemically reacting system at equilibrium is (a) Minimum (b) Maximum (c) Can not be predicted (d) None of these.
-
The post-closing trial balance of Violet Corporation at December 31, 2012, contains the following stockholders equity accounts. Preferred Stock (15,000 shares issued)........... $ 750,000 Common...
-
Alexandra's Boutique has the following transactions related to its top - selling Gucci purse for the month of October. Alexandra's Boutique uses a periodic inventory system. Date Transactions Units...
-
The shareholders equity accounts of Tmao Inc. at December 31, 2023, are as follows: Preferred shares, $3 noncumulative, unlimited number authorized, 4,000 issued ......... $400,000 Common shares,...
-
A stress of 25 MPa is applied to a 15 cm long rod of borosilicate glass held at a constant temperature. If the rod is to elongate no more than 0.1 cm in one year, what is the maximum temperature that...
-
30. The marginal benefit of Good X to Consumer A is $43, the price is $29, and the marginal cost of Good X to Company B is $17. Therefore, the consumer surplus in and the producer surplus is Use the...
-
Equation 1: 8 = 0.29 +0.9rgdp60, +2.43 tradeshare; (0.60) (0.09) (0.78) R0.14; R0.11;n - 65 Equation 2: 8 = 0.49 -0.47 rgdp60, +1.56 tradeshare, +0.57 yearsschool, -2.16 rev & coups; + 0.35 assa sin...
-
2. Let R and R be the i.i.d. random rates of return on two assets (with positive expected values). Assume the agent has only two options: put all his wealth in one asset, or divide it among the two....
-
QUESTION 10 What is the formula for calculating the present value of a future income stream at a specific discount rate? PV-Future Value divided by the discount rate PV = the sum of a stream of...
-
SECTION A Read the case study below and answer ALL the questions that follow. PIC FIRES INVESTMENT MANAGER IMPLICATED IN AYO DEAL The Public Investment Corporation has dismissed a portfolio manager...
-
We are given the following information about a product. Cost of placing an order = $100 Cost per item = $5 Sale price per item = $8 Annual holding cost = 40% of cost of item Expected Annual demand =...
-
Determine two different Hamilton circuits in each of the following graphs. A B F G
-
The signal at the input of an AM receiver is u(t) = m 1 (t) cos(20t) + m 2 (t) cos(100t) where the messages m i (t), i = 1, 2 are the outputs of a low-pass Butterworth filter with inputs x 1 (t) =...
-
A Butterworth low-pass discrete filter of order N has been designed to satisfy the following specifications: Sampling period T s =100 sec max = 0.7 dB for 0 f f p = 1000 Hz min = 10 dB for f st...
-
The smoothness of the signal determines the frequency content of its spectrum. Consider the signals x(t) = u(t + 0.5) u(t 0.5), y(t) = (1 + cos( t))[u(t + 0.5) u(t 0.5)] (a) Plot these signals....
-
True or False. The Euler-Bernoulli beam theory is more accurate than the Timoshenko theory.
-
Fixed end spring force a. Bending moment \(=0\); shear force equals the b. Deflection \(=0\); slope \(=0\) c. Deflection \(=0\); bending moment \(=0\) d. Bending moment \(=0\); shear force \(=0\)
-
Fill in the Blank. The Timoshenko beam theory can be considered as __________ beam theory.
Study smarter with the SolutionInn App