1. Please show work and state formulas for the problem questions Answer the following fifteen questions True or False The only important goal of product design is to obtain one hundred percent reliability 2 Redundancy in product design refers to using back-up parts or systems in design 3. If a system has two parts which must both operate for system to function and each has a reliability of 0.7, then it is more likely (than not) that the system will fail. Robust design implies a product that will perform satisfactorily only in a very narrow range of operating conditions. 5. QFD translates customer requirements into organization's workforce diversity In Statistical Process Control (SPC), it is possible for us to incorrectly conclude that the process is in control 7. Management and measurement of quality is more challenging in manufacturing sector because of strict (tight) tolerances on components and products. 8. Variables data is measured while Attribute data is counted or recorded. 9. Since "Process Mean" is the most important aspect of any process output, X-bar or Mean chart alone is sufficient to check if the process is in control. 10. All the components in parallel arrangement in product design do not have to work for the system to function 6. 11. The Deming Prize is the quality award given by the U.S. government to honor Dr. Deming for his contribution to quality and to promote quality in the U.S. businesses. 12. Functionality of the product is unaffected by its design. 13. Inspection is very desirable in operations management because it keeps the defectives from reaching the customers. 4. A process is said to be in control when assignable causes are the only sources of variation in the process output. Modern quality management (that is TQM) highly emphasizes finding defects and correcting them before they reach our customers