1. Switch on microprocessor training system M85-01 (power on switch on the rear end) and initiate the system monitor (press "RESET" key). 2. Draw a Table 4. Table 4. Results of the registers examination and modification Names (identifiers) of registers: A8-bit register A or accumulator; B8-bit register B; C8-bit register C; D-8-bit register D; E8-bit register E H8-bit register H; L8-bit register L; F - 8-bit flags register F; PCH - higher byte of the program counter PC; PCL - lower byte of the program counter PC; SPH - higher byte of the stack pointer SP; SPL - lower byte of the stack pointer SP. 3. Examine and modify the contents of all registers of the microprocessor (listed above). After that press "RESET" key and once again examine the contents of all registers. Write the results in Table 4. Make a conclusion