1m. What command is used to verify the routing protocol being used? What are two commands that can be used to display the routing protocol?

1n. What command displays only the EIGRP routes?

1o. What are wildcard bits or inverse mask bits?

Reference Tables For convenience, Table 1 provides the IP address and mask of all necessary interfaces used to complete the lab Table 1: The Computer IP Addresses, Subnet Masks, and Gateway Address for Lab 6 Computer/Interface - R1 IP Address 192. 1 68.2118 192.168.21.17 10.30.1.1 IP Address 192.168.85.21 192.168.85.18 10.30.1.2 Subnet Mask 255.255.255.240 255.255.255.240 255.255.255.252 Subnet Mask 255.255.255.240 255.255.255.240 255.255.255.252 Gateway Address PC1 R1-Fa0/1 R1-Fa0/(0 Computer/Interface - R2 192.168.21.17 Gateway Address 192.168.85.18 PC2 R2-Fa0/1 R2-Fa0/0 The commands used in these labs are based on the following: Router: Cisco IOS Version 12.4(7h) Switch: Cisco OS Version 12.2(25) Detailed Lab Steps In the following tasks, you demonstrate your knowledge to configure computer networks. Each task specifies a particular network setting you will be required to input. You will be required to document the command(s) used to accomplish each task. Task #1 In this lab you configure EIGRP routing to the adjacent LAN for the network shown in Figure 1. You are required to verify that computers in your LAN can ping the neighbor LAN