#29 Study Var %Study Var %Tolerance Source StdDev (SD) (6 % SD) (9%SV) (SV/Toler) I ne construction company performs a gage R&R study on Total Gage R&R 0.020129 0.12077 9.32 20.13 beam-width measurements taken with the caliper. If a 10% Repeatability 0.018597 0.11158 8.61 18.60 Reproducibleity 3.57 7.70 or less percentage of tolerance is considered acceptable to 0.007703 0.04622 Operator 0.000000 0.00000 0.00 0.00 the company, is the caliper adequate? Operator*Part 0.007703 0.04622 3.57 7.70 Part-To-Part 0.215117 1.29070 99.57 215.12 Total Variation 0.216057 1.29634 100.00 216.06 A) Yes; measurement system percentage of tolerance is less than part-to-part percentage of tolerance. B) Yes; measurement system variation contributes 9.32% of the total variation to the tolerance. C) No; repeatability variation contributes 18.6% of the measurement system variation to the tolerance. D) No; 20.13% of the tolerance is taken up by the measurement system variation