Question: ( 5 ) Use the conjugate - beam method and repeat problem ( 3 ) . ( 3 ) Use the moment - area method

(5) Use the conjugate-beam method and repeat problem (3).
(3) Use the moment-area method to determine the slope and deflection at boint C .
EI= constant
E=20GPa
I=500cm4
Only problem 5 please
( 5 ) Use the conjugate - beam method and repeat

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Civil Engineering Questions!

Q:

Determine the slope and deflection at point b . Using conjugate beam method and moment area method using moment by parts PLEASE USE THE 2 MEHODS

Q:

Problem 6 . 5 7 Use the conjugate beam method to determine the slope and deflection at point D of the beam shown. FIG. P 6 . 3 1 , P 6 . 5 7 Please make sure to use the Conjugate Beam Method!

Q:

Problem 6 . 1 8 Determine the smallest moment of inertia I required for the beam shown, so that its maximum deflection does not exceed the limit of 1 3 6 0 of the span length ( i . e . , D m a x L 3...

Q:

a . Determine the slope and deflection at C . El is constant. Use conjugate beam method. b . Determine the maximum deflection using area moment method.

Q:

A beam AB is subjected to loads as shown, with a constant flexural rigidity EI for the beam section: ( a ) Use the Conjugate Beam Method to determine the slope at point C after deformation. ( b ) Use...

Q:

A built - up section made up by rigidly joining equal - leg angles to steel plates ( Figure 1 ) is used as a horizontal cantilever beam. The beam is as shown in Figure 2 ( All dimensions are in mm )...

Q:

Module 4 Objectives: 1 . Apply moment area method to solve deflections in a beam or frame 2 . Apply conjugate beam method to solve deflections in a beam or frame 3 . Apply the method of virtual work...

Q:

TUTORIAL PROBLEMS T 4 . 1 Using moment area method, determine the end slope and deflection of the mid - span point C in the beam shown in Figure T 4 . 1 . T 4 . 2 Determine the slope and deflection...

Q:

can someone help me with this sample lab report? I didn't do so well with a similar one in the semester. what I'm most confused about is number 5 and 7. Bending Lab guidelines: 1. Follow the handout...

Q:

Problem 1 Determine the deflection at the left overhang of the beam loaded as shown below using the two methods indicated in the group of your choice. Choose and use only one group. ( No mixing of...

Q:

By java please and give a screen shot , take your time Q5) Use loop or recursion and the methods moveTo(), forward(), left(), right() to write code in java to draw the following shapes A)

Q:

The model in Section 5.5, Exercise 27. For the above problem, add direction arrows to the phase-plane.

Q:

The equivalent mass is the term that multiplies the acceleration the term that multiplies the velocity the term that multiplies the displacement the independent term

Q:

Iguana, Inc., manufactures bamboo picture frames that sell for $25 each. Each frame requires 4 linear feet of bamboo, which costs $2.00 per foot. Each frame takes approximately 30 minutes to build,...