Consider the plane frame structure shown in the figure below. The rotational springs attached to the...
Fantastic news! We've Found the answer you've been seeking!
Question:
Transcribed Image Text:
Consider the plane frame structure shown in the figure below. The rotational springs attached to the members represent a partially rigid foundation. A concentrated force and a moment are applied as indicated. Taking advantage of structural symmetry, analyze the structure by the direct stiffiness method. Clearly indicate the units used. Do NOT Neglect the axial deformation of the members. 20 kip 3 kip ft 0.4k/ft 6ft 1.34x10 kip tt/rad 1.34x10* kip-ft/rad Young's modulus of the beam elements is E = 29,000 ksi. The moment of inertia of the beam elements is I. - 200 in", The cross-sectional area of the beam elements is A- 25 in. The stiffness coefficient of the rotational spring element is ku - 1.34*10ʻ kip-fi'rad. i) Decompose the external loads to symmetric and anti-symmetric components. Draw % structures for symmetric und anti-symmetric loading components. (Clearly indicate ii) the boundary conditions for each case on the plane of symmetry) iii) With the symmetric component, analyze the left of the structure a. Compute nodal displacements and rotations b. Compute member end forces for frame and rotational spring element c. Compate reactions d. Draw the shear fore and bending moment diagrams for the entire structure With the anti-symmetric component, analyze the left % of the structure a Compute noodal displacements and rotations b. Compute member end forces for frame and rotational spring element c. Compute reactions d. Draw the shear force and bending moment diagrams for the entire structure iv) Using the principle of superposition and the results of (ii) and (iv), analyze the entire structure with the original loads. a Draw the shear force and bending moment diagrams for the entire structure b. Sketch the deflection of the entire structure Consider the plane frame structure shown in the figure below. The rotational springs attached to the members represent a partially rigid foundation. A concentrated force and a moment are applied as indicated. Taking advantage of structural symmetry, analyze the structure by the direct stiffiness method. Clearly indicate the units used. Do NOT Neglect the axial deformation of the members. 20 kip 3 kip ft 0.4k/ft 6ft 1.34x10 kip tt/rad 1.34x10* kip-ft/rad Young's modulus of the beam elements is E = 29,000 ksi. The moment of inertia of the beam elements is I. - 200 in", The cross-sectional area of the beam elements is A- 25 in. The stiffness coefficient of the rotational spring element is ku - 1.34*10ʻ kip-fi'rad. i) Decompose the external loads to symmetric and anti-symmetric components. Draw % structures for symmetric und anti-symmetric loading components. (Clearly indicate ii) the boundary conditions for each case on the plane of symmetry) iii) With the symmetric component, analyze the left of the structure a. Compute nodal displacements and rotations b. Compute member end forces for frame and rotational spring element c. Compate reactions d. Draw the shear fore and bending moment diagrams for the entire structure With the anti-symmetric component, analyze the left % of the structure a Compute noodal displacements and rotations b. Compute member end forces for frame and rotational spring element c. Compute reactions d. Draw the shear force and bending moment diagrams for the entire structure iv) Using the principle of superposition and the results of (ii) and (iv), analyze the entire structure with the original loads. a Draw the shear force and bending moment diagrams for the entire structure b. Sketch the deflection of the entire structure
Expert Answer:
Answer rating: 100% (QA)
Ans 5KNm 13m 5m 13m 13m Sim B 2 m 6m 6 m 0 fan 22620 12m 12m B C S5212 1... View the full answer
Related Book For
College Algebra Graphs and Models
ISBN: 978-0321845405
5th edition
Authors: Marvin L. Bittinger, Judith A. Beecher, David J. Ellenbogen, Judith A. Penna
Posted Date:
Students also viewed these civil engineering questions
-
The bridge support shown in the figure below is the top half of an ellipse. Assuming that a coordinate system is superimposed on the drawing in such a way that point Q, the center of the ellipse, is...
-
The two-wire lines shown in the figure below are lossless and have Z o =200 . Find d and shorted possible value for d 1 to provide a matched load if = 80 cm. Find the standing wave ratio for each of...
-
The closed loop shown in the figure below carries a current of 8 A in the counterclockwise direction. The radius of the outer arc is 60 cm, that of the inner arc is 20 cm. Find the magnetic field at...
-
1. If France can make 25 pounds of butter or 5 lamps while Spain can make 6 pounds of butter or 1 lamp, who has the comparative advantage in which good? A. France has the comparative advantage in...
-
Write three different equations for the graph at right. -2-
-
True Or False To prove private nuisance, a plaintiff must show that the defendants conduct was intentional, negligent, or abnormally dangerous.
-
Describe the kinds of information that should be gathered in preparation for the drafting of a premarital agreement.
-
When patients suffered from hemorrhagic fever, M*A*S*H doctors replaced lost sodium by administering a saline solution intravenously. However, headquarters (HQ) sent a treatment change disallowing...
-
Briefly describe any FOUR advantages of using comments in a program.
-
Based in Winnipeg, Manitoba, Defence Electronics Inc. (DEI) was founded to provide security systems, facilities controls and related services. DEI established a solid reputation for quality and the...
-
5. A solid is bounded below the sphere x + y+z2 plane z = 2, with density 8(x, y, z) = M 1 2 4z and above the and mass m = 2. Use spherical coordinate to find z, which is the z-coordinate of the...
-
Use RSLogix5000 to draw a Ladder Logic Diagram of a garage door opener with the following: 1. The garage door is opened or closed using push-button switches X1, or remote control X2 and X3. 2....
-
The inverse demand function is P = 110 0.5q, and the inverse supply function is P = 320 +5q - 20r, where r is the rental cost of capital. a) Show how the equilibrium price and quantity vary with r?...
-
a. Use the given code to convert 'bit_stream' that is generated in Part I c. to a, and by, and plot the constellation. b. Convert a, and b, to delta functions and plot them into one figure, using...
-
Subtract. Simplify the result if possible. 2x + 3x x-3 8x+3 X-3
-
4. Analogous system: Obtain the electrical analogous of the following mechanical system using "force-voltage analogy." Assume x1 and x2 are displacement from the equilibrium point of the systems,...
-
4. A 3 MeV photon interacts with a lead nucleus and creates an electron-positron pair. The elec- tron and positron travel perpendicular to the initial direction of travel of the photon. Find the...
-
The senior management at Davis Watercraft would like to determine if it is possible to improve firm profitability by changing their existing product mix. Currently, the product mix is determined by...
-
Graph the equation. (a) 3x - 6y = 6 (b) y = - 1/2 x + 3
-
Quinn inherited $15,000 and invested it in two municipal bonds that pay 4% and 5% simple interest. The annual interest is $690. Find the amount invested at each rate.
-
Determine the leading term, the leading coefficient, and the degree of the polynomial. Then classify the polynomial as constant, linear, quadratic, cubic, or quartic. a. f (x) = 2x3 + 6x2 - x4 + 11...
-
A crystal sample of bacteriorhodpsin, a light-sensitive protein found in halobacteria that responds to light energy, has crystal planes separated by 0.20 nm. If a beam of 11 keV x rays illuminates a...
-
A nickel crystals work function is measured to be 5.22 eV at 25C. As the temperature increases by 300C, the work function drops by 50 meV. By how much does this shift the threshold wavelength for...
-
A study of photosynthesis in phytoplankton in the open ocean used short pulses of laser light to trigger photosynthetic reactions. The investigators system used 0.10 mW pulses of 640 nm laser light...
Study smarter with the SolutionInn App