Question: A diesel engine working on dual combustion cycle has a compression ratio 10 and cut off ratio 1.5. The pressure at the beginning of the

A diesel engine working on dual combustion cycle has a compression ratio 10 and cut off ratio 1.5. The pressure at the beginning of the compression is 2 bar and the maximum pressure in the cycle is 100 bar.

Determine the thermal efficiency and the mean effective pressure of the cycle. Also calculate the actual mean effective pressure and the thermal efficiency of the cycle assuming the diagram efficiency to be 0.75 and the mechanical efficiency to be 0.82.

Step by Step Solution

★★★★★

3.43 Rating (153 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

Given data compression ratio V10 cut off ratio Vc15 initial pressure P2 bar maxi... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

1. A Brayton cycle has a compression ratio of 9. Find the cycle efficiency. 2. A Brayton cycle has an initial air temperature of 30 o C. If the pressure ratio is 12, find the compressor work. 3. A...

An ideal Otto cycle has a compression ratio of 9.2 and uses air as the working fluid. At the beginning of the compression process, air is at 98 kPa and 27C. The pressure is doubled during the...

An ideal Otto cycle has a compression ratio of 10.5, takes in air at 90 kPa and 40oC, and is repeated 2500 times per minute. Using constant specific heats at room temperature, determine the thermal...

The following data refer to an analysis of a dual combustion cycle with a gas having specific heats varying linearly with temperature: The pressure and temperature of the gas at the end of...

if some one would be able to help me describe Hisco's company using the Strengths, Weaknesses, Opportunities, and Threats (SWOT Analysis) based on the information provided. Also,what the best...

Estimate (a) The heat transfer coefficient for a spherical fuel droplet injected into a diesel engine at 80C and 90 m/s. The oil droplet is 0.025 mm in diameter, the cylinder pressure is 4800 kPa,...

The compressor in an ideal refrigeration cycle using R134a has an inlet pressure of 120 kPa. Referring to Fig. 104, state 1 has a quality of 1.0 and state 4 has a quality of 0.4. For a cooling load...

A four-stroke diesel engine working at sea level (pressure 1 bar and temperature 19 C) develops a brake power of 310 kW with a volumetric efficiency of 86 % at sea level conditions. The engine works...

Please complete the assignment and t explain all the ratios that was use and effect. Table of Contents UNITED STATES SECURITIES AND EXCHANGE COMMISSION WASHINGTON, D.C. 20549...

1. Explain the principles of facilities layout and list types of layout. 2.(a) Explain the symptoms of poor production planning and control in a manufacturing organisation. (b) Describe with example...

A statement quoted in this chapter was, Use of aspirin for five years or longer was tied to a 30-percent reduction in skin cancer risk [for women aged 50 to 79], according to findings published in...

Derive the control volume energy balance equation for three-dimensional transient conduction with heat generation in a rectangular coordinate system.GIVENThree-dimensional transient conduction with...

Lockboxes and Collection Time (LO2) Norton Treehouses Inc., a Nova Scotiabased company, has determined that a majority of its customers are located in the Quebec area. It therefore is considering...

Calculate / report the mean and standard deviation of NPV what is he probability that the project will have a positive NPV? What is the probability that NPV will exceed $10,000? What is the...

What key insights does the GEMS study provide us about entrepreneurship?

You have 500 data points, which are normally distributed with a mean of 400 and a standard deviation of 50. All scores are integers. Then one new data point is added, which is far above the top end...

It is evident that some call handlers are very unhappy and feel that their job is adversely affecting their mental health. The CCM is concerned and wants to take action to improve the situation. (a)...

give a brief description of a the model 7113 in the avery-Denison range of universal testing machines .

is the last option correct Experiments in the selection of fruit flies for starvation resistance: OOO0 O show different results every time the experiment is conducted. cannot provide supporting...

The dual combustion cycle uses a compression ratio of 12:1. The cut off ratio is 2:1. If the temperature and pressure before compression are 30C and 1 bar and the maximum cycle temperature is 1700 K...

5. The dual combustion cycle uses a compression ratio of 12:1. The cut off ratio is 2:1. If the temperature and pressure before compression are 30C and 1 bar and the maximum cycle temperature is...

In an SI engine working on the ideal Otto cycle, the compression ratio is 5.5. The pressure and temperature at the beginning of compression are 1 bar and 27 C, respectively. The peak pressure is 30...

Analyze a 2001 Chevrolet Duramax 6.6 L turbo diesel engine using the air-standard Diesel cycle that addresses the "real" effects of non-isentropic compression/expansion, air-fuel ratio, fuel heating...

A six-cylinder, four-stroke, 4.5-L compression-ignition engine operates on the ideal diesel cycle with a compression ratio of 17. The air is at 95 kPa and 55C at the beginning of the compression...

A compression ignition engine for a small truck is to operate on an air-standard Dual cycle with a compression ratio of r c = 18. Due to structural limitations, maximum allowable pressure in the...