Question: A half - wave controlled rectifier circuit is connected to a purely resistive load. When m i n = 1 0 . The latching and

A half-wave controlled rectifier circuit is connected to a purely resistive load. When min=10. The latching and holding current for thyristor are 10 mA and 5 mA respectively. The circuit is operated from v=100sin314t
Q.11 The maximum value of the resistance to be connected as a load is
Q.12 The angle of conduction of thyristor is q, degree.
A half - wave controlled rectifier circuit is

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

(a)What are the 5 characteristics of an ideal power semiconductor switch? (b)The latching current of a thyristor circuit in Fig. Q1(c) is 50 mA. The duration ofthe firing pulse is 50 s. Will the...

Q:

1. Define organization Behavior. 2. List the types of personality. 3. Difference between emotional intelligence and emotional Labour. 4. What do you understand by group dynamics? 5. Define...

Q:

Computer science!!! 2. Single phase half wave circuit with R-L load Vesna 11. Output current i, rises gradually. After some time i, reaches a maximum value and then begins to decrease. At , Vo =0 but...

Q:

Question 1: The flux per pole in a synchronous motor with the field circuit ON and the startor disconnected from the supply is found to be 25 mWb. When startor is connected to the rated supply with...

Q:

Computer.. control technique is explained with reference to a single phase full wave ac voltage controller circuit shown below. The thyristor switches T1 and T2 are turned on by applying appropriate...

Q:

1 4 - Single phase half bridge inverters requires a ) two wire ac supply b ) two wire de supply c ) three wire ac supply d ) three wire dc supply 1 5 . Find the average value of output current of a...

Q:

Part (3) half wave controlled rectifier Use the Multisim software to build the half wave controlled rectifier shown below: Part (3) half wave controlled rectifier Use the Multisim software to build...

Q:

A battery is charged through a single phase half wave controlled converter. The supply voltage is 230 V, 50 Hz and battery emf is constant at 160 V. Find the value of average charging current for...

Q:

In the three-phase half wave controlled rectifier used as a charger as shown in Fig.(Q1), the resistance is equal to 1.20 and the battery voltage is E. Transformer secondary voltage is 16 sin wt. 1....

Q:

Q2 - LEARNING ACTIVITY SHEET (LAS) 3 SHS - General Physics 1 Name: Section: Directions: Read each question carefully Ill. The restoring force and and choose the letter of the best answer....

Q:

Reconsider Prob. 1026. Now, it is proposed that the liquid water coming out of the separator be used as the heat source in a binary cycle with isobutane as the working fluid. Geothermal liquid water...

Q:

A survey of a local market has provided the following average cost data: Johnson Construction Corp. (JCC) has assets of $3 million and an average cost of 20 percent. Anderson Architects (AA) has...

Q:

4. What special purpose does the ECX register serve?

Q:

A new investment opportunity for you is an annuity that pays$550 at the END of each year for 3 years. You could earn a rate ofreturn of 5.5% per year on your money in other, similarinvestments. Wha 2...