Question: A horizontal curve is designed for a two - lane road given an intersection angle of 3 0 . The station of the PC is

A horizontal curve is designed for a two-lane road given an intersection angle of 30. The station of the PC is at 544+30 and the radius is 2500 ft . Determine the following:
A. Degree of curvature, D
B. Station of the PT
C. Deflection angle and chord length to the first even 100 ft station (e.g.N=1).
D. Deflection angle and chord length to the second even 100 ft station (e.g.N=2).
E. Deflection angle and chord length to the last even 100 ft station (e.g. N-1).
A horizontal curve is designed for a two - lane

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Civil Engineering Questions!

Q:

1. 2. 3. 4. 5. The slope of the outside edge of pavement on a superelevation development is 0.5%, as shown on the diagram. For a two-lane road (3.6 m lanes) and emax = 10%, what is the length of the...

Q:

A 4 - lane Urban road, with lane width of 3 . 3 m crowned at 2 % cross slope is being designed for a speed of 7 0 k m h and maximum superelevation of 4 % . A horizontal curve with the following...

Q:

Road Design assignment The objective of this assignment is to apply what you have learned to design a road connecting two existing roads. The attached map shows the tangents ( in bold ) that you will...

Q:

USE Regestration No = 99 Q.No.1 Capital Development Authority (CDA) plans to provide a new connection between sectors G-9 and G-8 with the help of a highway. The new highway will run east-west and...

Q:

Problem Description Mydland, Arizona has been experiencing rapid traffic growth in recent years due to many new commercial and residential developments. To alleviate congestion and enhance safety, a...

Q:

A 4-lane divided highway is to be designed to connect two points A and B. One horizontal curve and two vertical curves are adopted to provide the safest and most economical design. Figures 1 and 2...

Q:

Vertical curve example: A curve has initial and final grades of 2 . 5 % and - 1 % , respectively, and is 9 0 0 f t long. The P V C is at elevation 2 0 0 f t . Graph the vertical curve elevations and...

Q:

Challenge 1 . Consider a segment of highway composed of a horizontal curve and a sag curve ( equal - tangent ) . Both curves have the same design speed. The horizontal curve has a superelevation e =...

Q:

1. A simple horizontal curve connects two tangents that intersect at an angle of 30. The point of intersection(PI) is located at station(524+12). If the design speed of the highway is 100km/h,...

Q:

A highway is designed as two - way double lane and its project velocity is 8 0 k m h . The data about the highway is provided below. Project Data P C k m = 0 + 3 1 5 P T k m = 0 + 4 5 2 = 3 2 , 7 1...

Q:

Define and distinguish between the nominal (stated) rate of interest and the effective rate of interest. Explain why a savings and loan association that pays a nominal rate of 4.5 percent interest,...

Q:

What is the definition of single loss expectancy? What is annual loss expectancy?

Q:

How much money did Stacy and Dustin Dam, the founders of Set Your Sites raise upon completion of their pre - seed round of fundraising? Group of answer choices $ 2 0 , 0 0 0 $ 2 0 0 K $ 6 0 0 K $ 1...

Q:

Gladstone Company tracks the number units purchased and sold throughout each accounting period but applies its inventory costing method at the end of each period, as if it uses a periodic inventory...